89-05-02 BEECH: Amendment 39-6144. Applicability: The airplanes listed below, certificated in any category:
MODELS
SERIAL NUMBERS
35-33, 35-A33, 35-B33, 35-C33, E33
CD-1 through CD-1234
35-C33A, E33A
CE-1 through CE-289
E33C
CJ-1 through CJ-25
35, 35R, A35, B35, C35, D35, E35, F35, G35, H35, J35, K35, M35, N35, P35,
S35, V35, V35-TC, V35A, V35A-TC
D-1 through D-9068, D-15001 and D-15002
36
E-1 through E-184
95-55, 95-A55, 95-B55, 95-B55A
TC-1 through TC-1287
95-C55, 95-C55A, D55, D55A
TE-1 through TE-767
56TC
TG-2 through TG-83
95, B95, B95A, D95A, E95
TD-2 through TD-721
This AD also applies to any of the following military airplanes which have been modified for civil certification as described on the applicable Federal Aviation Administration Type Certificate Data Sheet or Aviation Specification:
T34A, T34B (Commercial Model 45 Series)
T42A (Commercial Model 95-B55B)
NOTE: The magnesium fittings may have been installed as original equipment or as replacement spares.
Compliance: Required as indicated, unless already accomplished.
To prevent the failure of the magnesium elevator control fittings, accomplish the following:
(a) Within 100 hours time-in-service (TIS) after the effective date of this AD, determine the composition of the elevator control fittings in accordance with the instructions contained in Beech Service Bulletin No. 2242, Revision 1, dated August 1988.
(1) If the fittings are determined to be aluminum, no further action is required by this AD.
(2) If the fittings are determined to be magnesium, accomplish the actions specified below.
(b) At the time of the inspection per paragraph (a), and every 100 hours TIS thereafter, visually inspect each magnesium elevator control fitting for cracks in accordance with the above referenced Service Bulletin.
(c) If any fitting is found to be cracked, prior to further flight replace the cracked fitting with an aluminum fitting as described in the above referenced Service Bulletin.
(d) The above inspections are no longer required when aluminum fittings have been installed on both elevators.
(e) Airplanes may be flown in accordance with FAR 21.197 to a location where this AD may be accomplished.
(f) An equivalent means of compliance with this AD may be used if approved by the Manager, FAA, Wichita Aircraft Certification Office, 1801 Airport Road, Room 100, Mid-Continent Airport, Wichita, Kansas 67209; Telephone (316) 946-4400.
All persons affected by this directive may obtain copies of the documents referred to herein upon request to Beechcraft Aero and Aviation Centers; Beech Aircraft Corporation, Commercial Service, Dept. 52, P.O. Box 85, Wichita, Kansas 67201-0085, or may examine these documents at the FAA, Office of the Assistant Chief Counsel, Room 1558, 601 East 12th Street, Kansas City, Missouri 64106.
This amendment (39-6144, AD 89-05-02) becomes effective on March 24, 1989.