AD 97-09-03

Active

Hydraulic Shutoff Valve Wiring

Key Information
97-09-03
Active
May 29, 1997
Not specified
96-NM-169-AD
39-9999
Applicability
["Aircraft"]
["Large Airplane"]
Airbus
A310-203 A310-221 A310-222 A310-304 A310-322 A310-324 A310-325
Summary

This amendment adopts a new airworthiness directive (AD), applicable to certain Airbus Model A310 series airplanes, that requires modification of the wiring for certain hydraulic fire shutoff valves to the right engine to prevent chafing. This amendment is prompted by reports indicating that a circuit breaker to wiring in the right engine had tripped on two airplanes, the cause of which has been attributed to chafing of the associated wire bundle. The actions specified by this AD are intended to prevent this wiring from chafing which, if not corrected, could lead to short circuiting of this wiring and the consequent inability to close the hydraulic fire shutoff valves to the right engine in the event of fire.

Action Required

Final rule.

Regulatory Text

97-09-03 AIRBUS INDUSTRIE: Amendment 39-9999. Docket 96-NM-169-AD.

Applicability: Model A310 series airplanes as listed in Airbus Service Bulletin A310-24- 2065, dated November 30, 1995, and Revision 1, dated April 19, 1996; certificated in any category.

NOTE 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been otherwise modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions toaddress it.

Compliance: Required as indicated, unless accomplished previously.

To prevent chafing of wire bundles for the hydraulic fire shutoff valves to the right engine, which could lead to short circuiting of this wiring and the consequent inability to close these valves in the event of fire, accomplish the following:

(a) Within 60 days after the effective date of this AD, modify the wiring for the hydraulic fire shutoff valves in wire bundles 626VB and 628VB, and modify wire bundle 632VB, in accordance with Airbus Service Bulletin A310-24-2065, dated November 30, 1995, or Revision 1, dated April 19, 1996, as applicable.

(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Standardization Branch, ANM-113, FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Standardization Branch, ANM-113.

NOTE 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Standardization Branch, ANM-113.

(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

(d) The modifications shall be done in accordance with Airbus Service Bulletin A310-24-2065, dated November 30, 1995, or Airbus Service Bulletin A310-24-2065, Revision 1, dated April 19, 1996, as applicable. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Airbus Industrie, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

(e) This amendment becomes effective on May 29, 1997.

Supplementary Information

A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain Airbus Model A310 series airplanes was published in the Federal Register on January 27, 1997 (62 FR 3836). That action proposed to require modification of the wiring for certain hydraulic fire shutoff valves to the right engine to prevent chafing.

Interested persons have been afforded an opportunity to participate in the making of this amendment. Due consideration has been given to the single comment received.

The commenter supports the proposed rule.

Conclusion
After careful review of the available data, including the comment noted above, the FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

Cost Impact
The FAA estimates that 20 Airbus Model A310 series airplanes of U.S. registry will be affected by this AD, that it will take approximately 4 work hours per airplane to accomplish the required actions, and that the average labor rate is $60 per work hour. Required parts will be provided by the manufacturer at no cost to operators. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $4,800, or $240 per airplane.

The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted.

Regulatory Impact
The regulations adopted herein will not have substantial direct effects on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, in accordance with Executive Order 12612, it is determined that this final rule does not have sufficient federalism implications to warrant the preparation ofa Federalism Assessment.

For the reasons discussed above, I certify that this action (1) is not a significant regulatory action under Executive Order 12866; (2) is not a significant rule under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39 - AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
39.13 - [Amended]
2. Section 39.13 is amended by adding the following new airworthiness directive:

AD Assistant

Get AI-powered answers about this AD, check applicability, and find compliance steps.

Sign Up to Unlock
Contact Information

Charles Huber, Aerospace Engineer, Standardization Branch, ANM-113, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (206) 227-2589; fax (206) 227-1149.

References
This information is not available.
--- - Part 39 [62 FR 19919 NO. 79 04/24/97]
FAA Documents