98-04-11 AIRBUS INDUSTRIE: Amendment 39-10324. Docket 97-NM-150-AD.
Applicability: Model A320 and A321 series airplanes on which Airbus Modification No. 24745 (Airbus Service Bulletin A320-27-1088, Revision 3, dated December 11, 1996) has not been accomplished, certificated in any category.
NOTE 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been otherwise modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request shouldinclude specific proposed actions to address it.
Compliance: Required as indicated, unless accomplished previously.
To prevent possible delays in deceleration when landing with strong cross winds and/or on a contaminated runway, which could increase the potential for landing overrun, accomplish the following:
(a) Within 12 months after the effective date of this AD, activate the spoiler "phased lift dumping" function by modifying the aircraft wiring at the level of the three spoiler elevator computer (SEC) connectors, in accordance with Airbus Service Bulletin A320-27-1088, Revision 03, dated December 11, 1996.
(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then sendit to the Manager, International Branch, ANM-116.
NOTE 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the International Branch, ANM-116.
(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.
(d) The actions shall be done in accordance with Airbus Service Bulletin A320-27- 1088, Revision 03, dated December 11, 1996. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Airbus Industrie, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register,800 North Capitol Street, NW., suite 700, Washington, DC.
NOTE 3: The subject of this AD is addressed in French airworthiness directive 96-169- 081(B), dated August 28, 1996.
(e) This amendment becomes effective on March 24, 1998.