AD 93-12-02

Active

Install Protective Shield

Key Information
93-12-02
Active
July 22, 1993
Not specified
93-NM-02-AD
39-8607
Applicability
["Aircraft"]
["Large Airplane"]
Saab AB, Saab Aerosystems
SAAB 340B 340A (SAAB SF340A)
Action Required

Final rule

Regulatory Text

93-12-02 SAAB-SCANIA: Amendment 39-8607. Docket 93-NM-02-AD.
Applicability: Model SAAB SF340A series airplanes, serial numbers 004 through 159, inclusive; Model SAAB 340B series airplanes, serial numbers 160 through 252, inclusive, and 254 through 258, inclusive; certificated in any category.

Compliance: Required as indicated, unless accomplished previously.

To prevent reduced structural integrity of the fuselage, accomplish the following:

(a) Within 3,000 hours time-in-service after the effective date of this AD, install an additional protective shield between the existing heat protection and the air cycle machine, in accordance with SAAB 340 Service Bulletin SAAB 340-53-028, dated August 20, 1992.

(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Standardization Branch, ANM-113, FAA, Transport Airplane Directorate. Operators shall submit theirrequests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Standardization Branch, ANM-113.

NOTE: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Standardization Branch, ANM-113.

(c) Special flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate the airplane to a location where the requirements of this AD can be accomplished.

(d) The installation shall be done in accordance with SAAB 340 Service Bulletin SAAB 340-53-028, dated August 20, 1992. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR Part 51. Copies may be obtained from SAAB-SCANIA AB, SAAB Aircraft Product Support, S-581.88, Linkoping, Sweden. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

(e) This amendment becomes effective on July 22, 1993.

AD Assistant

Get AI-powered answers about this AD, check applicability, and find compliance steps.

Sign Up to Unlock
References
This information is not available.
--- - Part 39
FAA Documents