95-11-16 SOCATA GROUPE AEROSPATIALE: Amendment 39-9249; Docket No. 94-CE- 26-AD.
Applicability: TBM 700 airplanes, serial numbers 1 to 49, certificated in any category.
NOTE 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must use the authority provided in paragraph (c) of this AD to request approval from the FAA. This approval may address either no action, if the current configuration eliminates the unsafe condition, or different actions necessary to address the unsafe condition described in this AD. Such a request should include an assessment of the effect of the changed configuration on the unsafe condition addressed by this AD. In no case does the presence of any modification, alteration, or repair remove any airplane from the applicability of this AD.
Compliance: Required within the next 100 hours time-in-service after the effective date of this AD, unless already accomplished.
To prevent ice accumulation on the elevator horn, which could lead to loss of control of the airplane, accomplish the following:
(a) Install pneumatic deicers on the elevator horn leading edges in accordance with Socata Technical Instruction of Modification No. OPT70 K020-30, dated February 1993. This installation is referenced in Socata TBM Service Bulletin SB 70-020-30, dated February 1993.
(b) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.
(c) An alternative method of compliance or adjustment of the compliance time that provides an equivalent level of safety may be approved by the Manager, Brussels Aircraft Certification Office (ACO), FAA, Europe, Africa, and Middle East Office, c/o American Embassy, B-1000 Brussels, Belgium. The request shall be forwarded through an appropriate FAA Maintenance Inspector, who may add comments and then send it to the Manager, Brussels ACO.
NOTE 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Brussels ACO.
(d) The installation required by this AD shall be done in accordance with Socata Technical Instruction of Modification No. OPT70 K020-30, dated February 1993. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from SOCATA Groupe AEROSPATIALE, Socata Product Support, Aeroport Tarbes-Ossun-Lourdes, B P 930, 65009 Tarbes Cedex, France; or the Product Support Manager, U.S. AEROSPATIALE, 2701 ForumDrive, Grand Prairie, Texas 75053. Copies may be inspected at the FAA, Central Region, Office of the Assistant Chief Counsel, Room 1558, 601 E. 12th Street, Kansas City, Missouri, or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
(e) This amendment becomes effective on July 19, 1995.