97-02-06 FOKKER: Amendment 39-9890. Docket 96-NM-79-AD.
Applicability: Model F27 Mark 050 series airplanes, as listed in Fokker Service Bulletin SBF50-25-046, Revision 1, dated August 5, 1994; and Model F28 Mark 0100 series airplanes, as listed in Fokker Service Bulletin SBF100-25-069, dated July 13, 1994, as revised by Service Bulletin Change Notification (SBCN) SBF100-25-069/01, dated February 15, 1995; certificated in any category.
NOTE 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.
Compliance: Required as indicated, unless accomplished previously.
To prevent improper grounding of the housing of the lavatory pump and filter assembly, which could result in an electrical fire and/or injury to passengers and crewmembers, accomplish the following:
(a) Within 6 months after the effective date of this AD, install a bonding cable for the housing of the lavatory pump and filter assembly and the lavatory bowl in accordance with Fokker Service Bulletin SBF50-25-046, Revision 1, dated August 5, 1994 (for Model F27 Mark 050 series airplanes); and Service Bulletin SBF100-25-069, dated July 13, 1994, as revised by Service Bulletin Change Notification (SBCN) SBF100-25-069/01, dated February 15, 1995 (for Model F28 Mark 0100 series airplanes); as applicable.
(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Standardization Branch, ANM-113, FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Standardization Branch, ANM-113.
NOTE 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Standardization Branch, ANM-113.
(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.
(d) The installation shall be done in accordance with Fokker Service Bulletin SBF50-25- 046, Revision 1, dated August 5, 1994; and Fokker Service Bulletin SBF100-25-069,dated July 13, 1994, as revised by Service Bulletin Change Notification (SBCN) SBF100-25-069/01, dated February, 15, 1995; as applicable. Fokker Service Bulletin SBF50-25-046, Revision 1, dated August 5, 1994, contains the following list of effective pages:
Page Number
Revision Level
Shown on Page
Date
Shown on Page
1
1
August 5, 1994
2-3
Original
August 1, 1994
This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Fokker Services B.V., Technical Support Department, P.O. Box 75047, 1117 ZN Schiphol Airport, The Netherlands. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
(e) This amendment becomes effective on February 27, 1997.