AD 73-19-10

Active

Elevator Control Horn

Key Information
73-19-10
Active
August 29, 1979
Not specified
Unknown
39-3544
Applicability
["Aircraft"]
["Small Airplane"]
Allied Ag Cat Productions, Inc.
G-164A G-164B G-164B-15T G-164B-20T G-164B-34T G-164B (with 73 inch wing gap)
Regulatory Text

73-19-10 GRUMMAN AIRCRAFT: Amendment 39-1719 as amended by Amendments 39-1757 and 39-1828 is further amended by Amendment 39-3544. Applies to G-164A S/N's 1 through 1659A and G-164B S/N's 1B through 56B certificated in all categories and all G-164A and G-164B aircraft in which the elevator control horn assembly and torque tube end fittings have not been modified per Gulfstream American Service Note No. 23 or FAA-approved equivalent.

Compliance required as indicated.

1. Within the next 25 hours in service or two weeks, whichever occurs first, unless already accomplished within the last 75 hours in service, inspect the bolts attaching the Elevator Control Horn, P/N A 1841-3, to the left and right side elevator, P/N A1201-5A and A1201-4A respectively, for a standard (ref. AC 43.13-1 Chg. 7) torque rating and for corrosion and thereafter at intervals not to exceed 100 hours in service or 60 days, whichever occurs first.

2. If any looseness is detected, the bolts must be removed and inspected for wear.

3. Replace any worn or corroded bolts with bolts of the same part number or NAS 1304-12 bolts or an equivalent as approved by the Chief, Engineering and Manufacturing Branch, FAA Eastern Region, except that the aircraft may be flown in accordance with FAR 21.197.

4. The bolts referenced in paragraph 3, must be replaced at intervals not exceeding 1000 hours in service or one year, whichever occurs first.

5. Upon submission of substantiating data by an owner or operator through an FAA Maintenance Inspector, the Chief, Engineering and Manufacturing Branch, FAA Eastern Region, may adjust the inspection intervals specified in this AD.

6. The repetitive inspection intervals required by paragraph 1 may be discontinued upon accomplishment of the modification in Grumman Gulfstream Service Note No. 23 dated 8/1/76, or an FAA-approved equivalent.

7. Any equivalent parts or alterations must be approved by the Chief, Engineering and Manufacturing Branch, FAA, Eastern Region.

(Grumman American Aviation Corporation AgCat Service Bulletin No. 51 pertains to this subject.)

Amendment 39-1719 was effective September 21, 1973.

Amendment 39-1757 was effective December 20, 1973.

Amendment 39-1828 was effective May 6, 1974.

This Amendment 39-3544 is effective August 29, 1979.

AD Assistant

Get AI-powered answers about this AD, check applicability, and find compliance steps.

Sign Up to Unlock
References
This information is not available.
--- - Part 39
FAA Documents