84-14-51 R1 BOEING: Amendment 39-5149. Applies to Model 757 airplanes listed in Boeing Service Bulletin 757-32-0033 dated September 7, 1984, certificated in any category, on which incorporation of Boeing Service Bulletin 757-32-0033, dated September 7, 1984, or later FAA- approved revision, has not been accomplished. Compliance is required as indicated below, after the effective date of this airworthiness directive (AD). To assure landing gear extension following a jam of the landing gear handle in the up position, accomplish the following, unless already accomplished: \n\n\tA.\tWithin 24 hours: \n\n\t\t1.\tIncorporate the following information into the FAA-approved airplane flight manual and the flight operations manual as an emergency procedure and provide to flight crews: \n\n\tGEAR LEVER WILL NOT MOVE FROM UP POSITION \n\t\tAIRSPEED.........................................................................\tMAINTAIN 200-220 KTS \n\t\tUNTIL GEAR EXTENDED \n\tFLAP LEVER.....................................................................\t................1 \n\tPTU CONT CIRCUIT BREAKER (D31)....................................\tPULL \n\tLEFT AUTOPILOT (IF ENGAGED)............................................DISCONNECT \n\tLEFT ELECTRIC AND ENGINE \n\t\tHYDRAULIC PUMP SWITCHES................................OFF \n\tALTERNATE GEAR EXTENSION SWITCH..........................PUSH \n\t\tIf, after 60 seconds, any gear down \n\t\t(green) lights not illuminated: \n\t\tFLAP LEVER.....................................................................\t5/1 \n\t\tSelect flaps 5 then 1. \n\t\tRepeat until all gear down (green) \n\t\tlights illuminate. \n\t-\tUse flaps 20 and VREF 20 for landing. \n\t-\tL thrust reverser and nose wheel steering \n\t\tinoperative \n\tGROUND PROXIMITY FLAPS OVERRIDE SWITCH........\tOVRD \n\tALTERNATE FLAPS SELECTOR.............................................SET \n\t\tPosition to agree with flap lever. \n\tALTERNATE FLAPS SWITCHES \n\t\t(Leading and Trailing Edge)........................................\tALTN \n\tALTERNATE FLAPS SELECTOR.............................................SET \n\t\tExtend or Retract Flaps as required. \n\n\tCAUTION:\tDO NOT REPRESSURIZE LEFT \n\t\t\tHYDRAULIC SYSTEM OR RESET PTU \n\t\t\tCONT CIRCUIT BREAKER INFLIGHT \n\t\t\tOR ON THE GROUND, AS GEAR WILL \n\t\t\tRETRACT. \n\n\tNOTE: Compliance with this directive may be effected by including a copy of telegraphic AD T84-14-51, issued June 29, 1984, in the airplane flight manual and operating manual. \n\n\t\t2.\tFurther revenue flight following landing gear jam is prohibited until repairs are made. \n\n\t\t3.\tAlternate means of compliance which provide an equivalent level of safety may be used when approved by the Manager, Seattle Aircraft Certification Office, FAA, Northwest Mountain Region. \n\n\t\t4.\tSpecial flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate airplanes to a base for the accomplishment of inspections and/or modifications required by this AD. \n\n\tB.\tPrior to September 1, 1986: \n\n\t\t1.\tModify the landing gear selector valve assembly, Boeing P/N 60B00216-7, in accordance with Boeing Service Bulletin 757-32-0033, dated September 7, 1984, or later FAA- approved revision. \n\n\t\t2.\tFollowing modification of the selector valve, the special emergency procedure implemented by paragraph A., above, may be removed. \n\n\tAll persons affected by this directive who have not already received these documents from the manufacturer may obtain copies upon request to the Boeing Commercial Airplane Company, P.O. Box 3707, Seattle, Washington 98124. These documents may be examined at the FAA, Northwest Mountain Region, 17900 Pacific Highway South, Seattle, Washington, or at the Seattle Aircraft Certification Office, 9010 East Marginal Way South, Seattle, Washington. \n\n\tThe telegraphic AD issued June 29, 1984, became effective upon receipt. \n\tThis amendment becomes effective November 12, 1985.