90-18-05 BOEING: Amendment 39-6713. Docket No. 89-NM-280-AD. \n\n\tApplicability: Model 767 series airplanes, line numbers 002 through 299, certificated in any category. \n\n\tCompliance: Required within the next 18 months after the effective date of this AD, unless previously accomplished. \n\n\tTo prevent structural failure of the vertical stabilizer from overpressurization in the event of a rupture of the fuselage under the dorsal fin, accomplish the following: \n\n\tA.\tInstall a cover plate and a panel assembly over the lightening and access holes in the vertical stabilizer forward closure rib, in accordance with Boeing Alert Service Bulletin 767- 55A0007, dated June 22, 1989. \n\n\tB.\tAn alternate means of compliance or adjustment of the compliance time, which provides an acceptable level of safety, may be used when approved by the Manager, Seattle Aircraft Certification Office (ACO), FAA, Transport Airplane Directorate. \n\n\tNOTE: The request should be submitted directly to the Manager, Seattle ACO, and a copy sent to the cognizant FAA Principal Inspector (PI). The PI will then forward comments or concurrence to the Seattle ACO. \n\n\tC.\tSpecial flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate airplanes to a base in order to comply with the requirements of this AD. \n\n\tAll persons affected by this directive who have not already received the appropriate service documents from the manufacturer may obtain copies upon request to Boeing Commercial Airplanes, P.O. Box 3707, Seattle, Washington 98124. These documents may be examined at the FAA, Northwest Mountain Region, Transport Airplane Directorate, 1601 Lind Avenue SW, 5th Floor, Renton, Washington, or Seattle Aircraft Certification Office, 1601 Lind Avenue SW, 2nd Floor, Renton, Washington. \n\n\tThis amendment (39-6713, AD 90-18-05) becomes effective on October 9, 1990.