AD 98-05-01

This amendment adopts a new airworthiness directive (AD), applicable to Eurocopter France Model SA-366G1 helicopters, with certain main rotor head frequency adapters (frequency adapters) installed. This proposal requires inspecting the frequency adapter to determine if a certain frequency adapter is installed, and if so, removing and discarding the frequency adapter and replacing it with an airworthy frequency adapter before further flight. This amendment is prompted by a report of disbonding of the metal center section of a frequency adapter from the elastomer, caused by a lack of adherence during the production process. The actions specified by this AD are intended to prevent vibrations caused by disbonding of the center section of a frequency adapter from the elastomer, that could result in loss of control of the helicopter.

Final rule

98-05-01 EUROCOPTER FRANCE: Amendment 39-10363. Docket No. 97-SW-09-AD.

Applicability: Model SA-366G1 helicopters, certificated in any category.

NOTE 1: This AD applies to each helicopter identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For helicopters that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must use the authority provided in paragraph (c) to request approval from the FAA. This approval may address either no action, if the current configuration eliminates the unsafe condition, or different actions necessary to address the unsafe condition described in this AD. Such a request should include an assessment of the effect of the changed configuration on the unsafe condition addressed by this AD. In no case does the presence of any modification, alteration, orrepair remove any helicopter from the applicability of this AD.

Compliance: Required within the next 100 hours time-in-service or 6 months after the effective date of this AD, whichever occurs first, unless accomplished previously.

To prevent vibrations caused by disbonding of the center section of a frequency adapter from the elastomer, that could result in loss of control of the helicopter, accomplish the following:

(a) Determine the part number, serial number, and date of manufacture of the main rotor head frequency adapter (frequency adapter).

(b) After making the determination in paragraph (a) and before further flight, if frequency adapter, part number (P/N) 704A33-640-031 (E1T2624-01A), or delivered in pairs under the P/N 365A31-1858-01, manufactured before April 1, 1991, with serial number (S/N) equal to or less than 8188; or P/N 704A33-640-046 (E1T3023-01), or delivered in pairs under the P/N 365A31-1858-02, manufactured before April 1, 1991, with S/N equal to or less than 3122 is installed, remove the frequency adapter and replace it with an airworthy frequency adapter.

NOTE 2: Eurocopter France SA-366 Service Bulletin No. 01.23, dated May 9, 1996, pertains to this AD.

(c) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, FAA Rotorcraft Directorate, Rotorcraft Standards Staff. Operators shall submit their requests through an FAA Principal Maintenance Inspector, who may concur or comment and then send it to the Manager, Rotorcraft Standards Staff.

NOTE 3: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Rotorcraft Standards Staff.

(d) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the helicopter to a location where the requirements of this AD can be accomplished.

NOTE 4: The subject of this AD is addressed in Direction Generale De L'Aviation Civile (France) AD 96-116-019(B), dated June 19, 1996.

(e) This amendment becomes effective on April 3, 1998.

A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to Eurocopter France Model SA-366G1 helicopters was published in the Federal Register on August 26, 1997 (62 FR 45183). That action proposed to require inspecting the frequency adapter to determine if a certain frequency adapter is installed, and if so, removing and discarding the frequency adapter and replacing it with an airworthy frequency adapter before further flight.

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were received on the proposal or the FAA's determination of the cost to the public. The FAA has determined that air safety and the public interest require the adoption of the rule as proposed except that Note 4 is added to this rule to provide a reference to the French AD. The FAA has determined that this change will neitherincrease the economic burden on an operator nor increase the scope of the AD.

The FAA estimates that 91 helicopters of U.S. registry will be affected by this AD, that it will take approximately 6 work hours per helicopter to accomplish the required actions, and that the average labor rate is $60 per work hour. Required parts will cost approximately $5,200 per helicopter. Based on these figures, the total cost impact of the AD on U.S. operators is estimated to be $505,960.

The regulations adopted herein will not have substantial direct effects on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, in accordance with Executive Order 12612, it is determined that this final rule does not have sufficient federalism implications to warrant the preparation of a Federalism Assessment.

For the reasons discussed above, I certifythat this action (1) is not a " significant regulatory action" under Executive Order 12866; (2) is not a "significant rule" under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption "ADDRESSES."

List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.

Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39 - AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.

39.13 [Amended]
2. Section 39.13 is amended by adding a new airworthiness directive to read as follows: