AD 74-10-08

Active

Horizontal Stabilizer

Key Information
74-10-08
Active
February 27, 1975
Not specified
Unknown
39-2073
Applicability
["Aircraft"]
["Large Airplane"]
The Boeing Company
727-100 Series 727-100C Series 727-200 Series 727-200F Series 727 Series 727C Series
Regulatory Text

74-10-08 BOEING: Amendment 39-1836 as amended by Amendment 39-2073. Applies to all model 727 series airplanes certificated in all categories. Compliance required as indicated. \n\t(A)\tUnless already accomplished on airplanes which have been delivered after September 30, 1973, or which have had new horizontal stabilizer hinge pins, P/N 69-14410, installed since that time, conduct the inspection and modification of paragraph (C) below, within the next 15 days after the effective date of this AD. \n\t(B)\tUnless already accomplished on all other airplanes, conduct the inspection and modification of paragraph (C) below, within the next 6 months after the effective date of this AD. \n\t(C)\tInspect the horizontal stabilizer hinge pins for integrity, replace as necessary, and install threaded retention rods, P/N 69-67076, or equivalent, in accordance with Boeing Alert Service Bulletin 727-55-59, or FAA approved revisions, or in a manner approved by the Chief, Engineering and Manufacturing Branch, FAA Northwest Region. \n\t(D)\tIf a threaded rod, P/N 69-67076-2, or an equivalent fabricated rod made from threaded rod NAS 1454-( )-( ), or any other rod with a Class 2 thread has been installed, unless already accomplished, conduct, before September 6, 1975, the hinge pin retainer nut torque inspection in accordance with Paragraph III, Part II of Boeing Alert Service Bulletin No. 727-55- 59, Revision 2, or later FAA approved revisions, or in a manner approved by the Chief, Engineering and Manufacturing Branch, FAA Northwest Region. \n\t\tIf the torque required to rotate the self-locking nut is less than 30 inch-pounds, replace the rod in accordance with Boeing Alert Service Bulletin No. 727-55-59, Revision 3, or later FAA approved revisions, or in a manner approved by the Chief, Engineering and Manufacturing Branch, FAA Northwest Region. \n\tThe Manufacturer's specifications and procedures identified and described in this directive are incorporated herein and made a part hereof pursuant to 5 U.S.C. 552(a)(1). All persons affected by this directive who have not already received these documents may obtain copies upon request to The Boeing Company, P. O. Box 3707, Seattle, Washington 98124. These documents may also be examined at FAA Northwest Region, Boeing Field, Seattle, Washington. \n\n\tAmendment 39-1836 became effective on May 10, 1974. \n\tThis Amendment 39-2073 becomes effective on February 27, 1975.

AD Assistant

Get AI-powered answers about this AD, check applicability, and find compliance steps.

Sign Up to Unlock
References
This information is not available.
--- - Part 39
FAA Documents