AD 2021-20-03

The FAA is adopting a new airworthiness directive (AD) for certain Leonardo S.p.a. Model AW169 helicopters. This AD was prompted by reports of in-flight pilot collective stick oscillation. This AD requires a one-time measurement of the friction of the pilot collective stick assembly to verify that it is within the allowable range and, depending on findings, making an adjustment to restore the acceptable level of friction, as specified in a European Aviation Safety Agency (now European Union Aviation Safety Agency) (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.

Final rule.

The Amendment \n\n\n\tAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n0 1. The authority citation for part 39 continues to read as follows: \n\n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\n\n\nSec. 39.13 (Amended) \n\n0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive: \n\n2021-20-03 Leonardo S.p.a.: Amendment 39-21741; Docket No. FAA-2021- 0578; Project Identifier 2018-SW-084-AD. \n\n(a) Effective Date \n\n\n\tThis airworthiness directive (AD) is effective November 22, 2021. \n\n(b) Affected ADs \n\n\n\tNone. \n\n(c) Applicability \n\n\n\tThis AD applies to Leonardo S.p.a. Model AW169 helicopters, certificated in any category, with an affected part as identified in European Aviation Safety Agency (now European Union Aviation Safety Agency) (EASA) AD 2018-0203, dated September 12, 2018 (EASA AD 2018- 0203) installed. \n\n(d) Subject \n\n\n\tJoint Aircraft Service Component (JASC) Codes: 6700, Rotorcraft Flight Control; 6710, Main Rotor Control. \n\n(e) Unsafe Condition \n\n\n\tThis AD was prompted by reports of in-flight pilot collective stick oscillation. The FAA is issuing this AD address incorrect adjustment of the pilot collective stick fixed friction. The unsafe condition, if not addressed, could result in reduced controllability of the helicopter, and subsequent damage to the helicopter and injury to occupants. \n\n(f) Compliance \n\n\n\tComply with this AD within the compliance times specified, unless already done. \n\n(g) Requirements \n\n\n\tExcept as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, EASA AD 2018-0203. \n\n((Page 57579)) \n\n(h) Exceptions to EASA AD 2018-0203 \n\n\n\t(1) Where EASA AD 2018-0203 refers to flight hours, this AD requires using hours time-in-service. \n\t(2) Where EASA AD 2018-0203 refers to its effective date,this AD requires using the effective date of this AD. \n\t(3) This AD does not mandate compliance with the ''Remarks'' section of EASA AD 2018-0203. \n\n(i) No Reporting Requirement \n\n\n\tAlthough the service information referenced in EASA AD 2018-0203 specifies to submit certain information to the manufacturer, this AD does not include that requirement. \n\n(j) Alternative Methods of Compliance (AMOCs) \n\n\n\t(1) The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the International Validation Branch, send it to the attention of the person identified in paragraph (k) of this AD. Information may be emailed to: 9-AVS-AIR-730-AMOC@faa.gov. \n\t(2) Before using any approved AMOC, notify your appropriateprincipal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. \n\n(k) Related Information \n\n\n\tFor more information about this AD, contact Darren Gassetto, Aerospace Engineer, COS Program Management Section, Operational Safety Branch, Compliance & Airworthiness Division, FAA, 1600 Stewart Ave., Suite 410, Westbury, NY 11590; telephone (516) 228- 7323; email Darren.Gassetto@faa.gov. \n\n(l) Material Incorporated by Reference \n\n\n\t(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. \n\t(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise. \n\t(i) European Aviation Safety Agency (EASA) AD 2018-0203, dated September 12, 2018. \n\t(ii) (Reserved) \n\t(3) For EASA AD 2018-0203, contact the EASA, Konrad-Adenauer- Ufer 3, 50668 Cologne, Germany; telephone +49 221 8999 000; email ADs@easa.europa.eu; internet www.easa.europa.eu. You may find this EASA AD on the EASA website at https://ad.easa.europa.eu. \n\t(4) You may view this material at the FAA, Office of the Regional Counsel, Southwest Region, 10101 Hillwood Pkwy., Room 6N- 321, Fort Worth, TX 76177. For information on the availability of this material at the FAA, call 817-222-5110. This material may be found in the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA- 2021-0578. \n\t(5) You may view this material that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email fr.inspection@nara.gov, or go to https://www.archives.gov/federal-register/cfr/ibr-locations.html. \n\n\n\tIssued on September 15, 2021. Gaetano A. Sciortino, Deputy Director for Strategic Initiatives, Compliance & Airworthiness Division, Aircraft Certification Service. (FR Doc. 2021-22463 Filed 10-15-21; 8:45 am) BILLING CODE 4910-13-P

Background \n\n\n\tEASA, which is the Technical Agent for the Member States of the European Union, has issued EASA AD 2018-0203, dated September 12, 2018 (EASA AD 2018-0203) (also referred to as the Mandatory Continuing Airworthiness Information, or the MCAI), to correct an unsafe condition for Leonardo S.p.A., formerly Finmeccanica S.p.A. and AgustaWestland S.p.A., Model AW169 helicopters, all serial numbers equipped with pilot collective stick assemblies having part number (P/N) 6F6711A07832 or P/ N 6F6711A07831. \n\tThe FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to certain Leonardo S.p.a. Model AW169 helicopters. The NPRM published in the Federal Register on July 23, 2021 (86 FR 38950). The NPRM was prompted by reports of in- flight pilot collective stick oscillation. The NPRM proposed to require a one-time measurement of the friction of the pilot collective stick assembly to verify that itis within the allowable range and, depending on findings, making an adjustment to restore the acceptable level of friction, as specified in EASA AD 2018-0203. \n\tThe FAA is issuing this AD to address incorrect adjustment of the pilot collective stick fixed friction. The unsafe condition, if not addressed, could result in reduced controllability of the helicopter, and subsequent damage to the helicopter and injury to occupants. See EASA AD 2018-0203 for additional background information. \n\nDiscussion of Final Airworthiness Directive \n\nComments \n\n\n\tThe FAA gave the public the opportunity to participate in developing this final rule. The FAA received no comments on the NPRM or on the determination of the cost to the public. \n\nConclusion \n\n\n\tThe FAA reviewed the relevant data and determined that air safety requires adopting this AD as proposed. Except for minor editorial changes, this AD is adopted as proposed in the NPRM. None of the changes will increase the economic burden on any operator. Accordingly, the FAA is issuing this AD to address the unsafe condition on these products. \n\nRelated Service Information Under 1 CFR Part 51 \n\n\n\tEASA AD 2018-0203 requires a one-time measurement of the friction of the \n\n((Page 57578)) \n\npilot collective stick assembly to verify that it is within the allowable range specified in the service information (collective up and collective down directions 9.00/18.00N (Newton) or 2.02/4.05 lbf (pound force)) and, depending on the findings, accomplishment of the corrective action. The corrective action is making an adjustment to the pilot collective stick assembly to restore the acceptable level of friction. EASA AD 2018-0203 also specifies that after installation of an affected part, or following maintenance of an affected part that involves removal from the helicopter and re-installation, before the next flight after the part installation, the collective fixed friction must be measured and, depending on the findings, the corrective action must be accomplished. \n\tThis material is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section. \n\nCosts of Compliance \n\n\n\tThe FAA estimates that this AD affects 6 helicopters of U.S. registry. The FAA estimates the following costs to comply with this AD: \n\n\n\tEstimated Costs for Required Actions ---------------------------------------------------------------------------------------------------------------- \n\tCost per Cost on U.S. \n\tAction Labor cost Parts cost product operators ---------------------------------------------------------------------------------------------------------------- Functional check-friction measurement. 2 work-hours x $85 per $0 $170 $1,020 \n\thour = $170. ---------------------------------------------------------------------------------------------------------------- \n\n\n\tThe FAA estimates the following costs to do any necessary adjustment that would be required based on the results of the inspection. The agency has no way of determining the number of helicopters that might need this adjustment: \n\n\n\tOn-Condition Costs ---------------------------------------------------------------------------------------------------------------- \n\tCost per \n\tAction Labor cost Parts cost product ---------------------------------------------------------------------------------------------------------------- Adjustment.................................. 2 work-hours x $85 per hour = $170 $0 $170 ---------------------------------------------------------------------------------------------------------------- \n\nAuthority for This Rulemaking \n\n\n\tTitle 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I,section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority. \n\tThe FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: General requirements. Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action. \n\nRegulatory Findings \n\n\n\tThis AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. \n\tFor the reasons discussed above, I certify that this AD: \n\t(1) Is not a ''significant regulatory action'' under Executive Order 12866, \n\t(2) Will not affect intrastate aviation in Alaska, and \n\t(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. \n\nList of Subjects in 14 CFR Part 39 \n\n\n\tAir transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.