AD 2021-10-26

The FAA is adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model BD-100-1A10 airplanes. This AD was prompted by reports of DC motor pump (DCMP) failures during production flight tests. This AD requires installing a redesigned DCMP electric motor assembly. The FAA is issuing this AD to address the unsafe condition on these products.

Final rule.

Adoption of the Amendment \n\n\n\tAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n0 1. The authority citation for part 39 continues to read as follows: \n\n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\n\n\nSec. 39.13 (Amended) \n\n0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive: \n\n2021-10-26 Bombardier, Inc.: Amendment 39-21559; Docket No. FAA- 2021-0097; Project Identifier MCAI-2020-01334-T. \n\n(a) Effective Date \n\n\n\tThis airworthiness directive (AD) is effective July 6, 2021. \n\n(b) Affected ADs \n\n\n\tNone. \n\n((Page 29187)) \n\n(c) Applicability \n\n\n\tThis AD applies to Bombardier, Inc., Model BD-100-1A10 airplanes, certificated in any category, serial numbers 20003 through 20406 inclusive. \n\n(d) Subject \n\n\n\tAir Transport Association (ATA) of America Code 29, Hydraulic power. \n\n(e) Reason \n\n\n\tThis AD was prompted byreports of DC motor pump (DCMP) failures during production flight tests. These failures caused the electrical system generators to disconnect due to excessive induced voltage in the bus, caused by the DCMP overheating at high altitudes. The FAA is issuing this AD to address failures of the DCMP and electrical system generators, which could lead to the loss of normal electrical power on the airplane. \n\n(f) Compliance \n\n\n\tComply with this AD within the compliance times specified, unless already done. \n\n(g) Required Actions \n\n\n\tWithin 6 months after the effective date of this AD: Install the redesigned DCMP electric motor assembly, having part number (P/N) 945202-3, in accordance with the Accomplishment Instructions of Bombardier Service Bulletin 100-29-18, Revision 03, dated December 18, 2014. \n\n(h) Parts Installation Prohibition \n\n\n\tAfter accomplishing the installation required by paragraph (g) of this AD, no person may install a DCMP having P/N MB74F-9/-7 on any airplane. \n\n(i) Credit for Previous Actions \n\n\n\tThis paragraph provides credit for actions required by paragraph (g) of this AD, if those actions were performed before the effective date of this AD using Bombardier Service Bulletin 100-29-18, dated July 2, 2013; Bombardier Service Bulletin 100-29-18, Revision 01, dated January 21, 2014; or Bombardier Service Bulletin 100-29-18, Revision 02, dated July 18, 2014. \n\n(j) Other FAA AD Provisions \n\n\n\tThe following provisions also apply to this AD: \n\t(1) Alternative Methods of Compliance (AMOCs): The Manager, New York ACO Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the manager of the certification office, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO Branch, 1600Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 516-228-7300; fax 516-794-5531. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office. \n\t(2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, New York ACO Branch, FAA; or Transport Canada Civil Aviation (TCCA); or Bombardier, Inc.'s TCCA Design Approval Organization (DAO). If approved by the DAO, the approval must include the DAO-authorized signature. \n\n(k) Related Information \n\n\n\t(1) Refer to Mandatory Continuing Airworthiness Information (MCAI) TCCA AD CF-2020-31, dated September 23, 2020, for related information. This MCAI may be found in the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2021-0097. \n\t(2) For more information about this AD, contact Steven Dzierzynski, Aerospace Engineer, Avionics and Electrical Systems Services Section, FAA, New York ACO Branch, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; phone: 516-228-7367; fax: 516-794- 5531; email: 9-avs-nyaco-cos@faa.gov. \n\t(3) Service information identified in this AD that is not incorporated by reference is available at the addresses specified in paragraphs (l)(3) and (4) of this AD. \n\n(l) Material Incorporated by Reference \n\n\n\t(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. \n\t(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise. \n\t(i) Bombardier Service Bulletin 100-29-18, Revision 03, dated December 18, 2014. \n\t(ii) (Reserved) \n\t(3) For service information identified in this AD, contact Bombardier, Inc., 200 Cote-Vertu RoadWest, Dorval, Quebec H4S 2A3, Canada; North America toll-free telephone 1- 866-538-1247 or direct-dial telephone 1-514-855-2999; email ac.yul@aero.bombardier.com; internet https://www.bombardier.com. \n\t(4) You may view this service information at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. \n\t(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email fedreg.legal@nara.gov, or go to: https://www.archives.gov/federal-register/cfr/ibr-locations.html. \n\n\n\tIssued on May 7, 2021. Gaetano A. Sciortino, Deputy Director for Strategic Initiatives, Compliance & Airworthiness Division, Aircraft Certification Service. (FR Doc. 2021-11426 Filed 5-28-21; 8:45 am) BILLING CODE 4910-13-P

Background \n\n\n\tTransport Canada Civil Aviation (TCCA), which is the aviation authority for Canada, has issued TCCA AD CF-2020-31, dated September 23, 2020 (TCCA AD CF-2020-31) (also referred to as the Mandatory Continuing Airworthiness Information, or the MCAI), to correct an unsafe condition for certain Bombardier, Inc., Model BD-100-1A10 airplanes. You may examine the MCAI in the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2021-0097. \n\tThe FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to certain Bombardier, Inc., Model BD-100-1A10 airplanes. The NPRM published in the Federal Register on February 24, 2021 (86 FR 11163). The NPRM was prompted by reports of DCMP failures during production flight tests. The NPRM proposed to require installing a redesigned DCMP electric motor assembly. The FAA is issuing this AD to address failures of the DCMP and electrical system generators, which could lead to the loss of normal electrical power on the airplane. See the MCAI for additional background information. \n\nComments \n\n\n\tThe FAA gave the public the opportunity to participate in developing this final rule. The FAA received no comments on the NPRM or on the determination of the cost to the public. \n\nConclusion \n\n\n\tThe FAA reviewed the relevant data and determined that air safety and the public interest require adopting this final rule as proposed, except for minor editorial changes. The FAA has determined that these minor changes: \n\tAre consistent with the intent that was proposed in the NPRM for addressing the unsafe condition; and \n\tDo not add any additional burden upon the public than was already proposed in the NPRM. \n\nRelated Service Information Under 1 CFR Part 51 \n\n\n\tBombardier has issued Service Bulletin 100-29-18, Revision 03, dated December 18, 2014. This service information describes procedures forinstalling the redesigned DCMP electric motor assembly, having part number (P/N) 945202-3 (including a wiring modification and a structural modification). This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section. \n\nCosts of Compliance \n\n\n\tThe FAA estimates that this AD affects 239 airplanes of U.S. registry. The FAA estimates the following costs to comply with this AD: \n\n\n\tEstimated Costs for Required Actions ---------------------------------------------------------------------------------------------------------------- \n\tCost per Cost on U.S. \n\tLabor cost Parts cost product operators ---------------------------------------------------------------------------------------------------------------- 68 work-hours x $85 per hour = $5,780........................ $18,964 $24,744 $5,913,816 ---------------------------------------------------------------------------------------------------------------- \n\nAuthority for This Rulemaking \n\n\n\tTitle 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority. \n\tThe FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: General requirements. Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action. \n\nRegulatory Findings \n\n\n\tThis AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. \n\tFor the reasons discussed above, I certify that this AD: \n\t(1) Is not a ''significant regulatory action'' under Executive Order 12866, \n\t(2) Will not affect intrastate aviation in Alaska, and \n\t(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. \n\nList of Subjects in 14 CFR Part 39 \n\n\n\tAir transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.