AD 2021-10-27

The FAA is adopting a new airworthiness directive (AD) for all BAE Systems (Operations) Limited Model BAe 146 and Model Avro 146-RJ series airplanes. This AD was prompted by a report indicating that during a routine battery capacity check on the emergency light power units, the printed circuit boards (PCBs) for certain power units were found to show signs of burning. This AD requires replacing each Honeywell emergency light power unit having a certain part number with a serviceable emergency light power unit. The FAA is issuing this AD to address the unsafe condition on these products.

Final rule.

Adoption of the Amendment \n\n\n\tAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39-AIRWORTHINESS DIRECTIVES \n\n1. The authority citation for part 39 continues to read as follows: \n\n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\n§ 39.13 (Amended) \n\n2. The FAA amends § 39.13 by adding the following new airworthiness directive: \n\n\n\n\n\nFAA Aviation Safety AIRWORTHINESS DIRECTIVE www.faa.gov/aircraft/safety/alerts/ www.gpoaccess.gov/fr/advanced.html \n\n2021-10-27 BAE Systems (Operations) Limited: Amendment 39-21560; Docket No. FAA-2021-0138; Project Identifier MCAI-2020-01466-T. \n\n(a) Effective Date \n\n\n\tThis airworthiness directive (AD) is effective June 17, 2021. \n\n(b) Affected ADs \n\n\n\tNone. \n\n(c) Applicability \n\n\n\tThis AD applies to all BAE Systems (Operations) Limited airplanes specified in paragraphs (c)(1) and (2) of this AD, certificated in any category. \n\t(1) Model BAe 146-100A,-200A, and -300A airplanes. \n\t(2) Model Avro 146-RJ70A, 146-RJ85A, and 146-RJ100A airplanes. \n\n(d) Subject \n\n\n\tAir Transport Association (ATA) of America Code 33, Lights. \n\n(e) Unsafe Condition \n\n\n\tThis AD was prompted by a report indicating that during a routine battery capacity check on the emergency light power units, the printed circuit boards (PCBs) for power units LE 10 and LE 22 (Illustrated Parts Catalog (IPC) 33-50-00) were found to show signs of burning. The FAA is issuing this AD to address heat damage of the PCBs, which could lead to battery discharge and possibly result in lack of power supply to the emergency light units when needed. \n\n(f) Compliance \n\n\n\tComply with this AD within the compliance times specified, unless already done. \n\n(g) Definitions \n\n\n\t(1) An affected part is defined as a Honeywell emergency light power unit, having part number 60-3550-1, except for those modified and marked using the instructions specified in Honeywell Service Bulletin 60-3550-33-0001, Revision 1, dated September 3, 2013. \n\t(2) A serviceable part is defined as an emergency light power unit that is not an affected part. \n\t(3) Group 1 airplanes are those that have an affected part installed. \n\t(4) Group 2 airplanes are those that do not have an affected part installed. \n\n(h) Replacement \n\n\n\tWithin two months after the effective date of this AD: Replace each affected part with a serviceable part. \n\n\n\tNote 1 to paragraph (h): BAE Systems (Operations) Limited Service Bulletin ISB.33-081, dated November 4, 2019, contains information related to the replacement specified in paragraph (h) of this AD. \n\n(i) Parts Installation Prohibition \n\n\n\tAs of the applicable compliance times specified in paragraphs (i)(1) or (2) of this AD, do not install an affected part on any airplane. \n\t(1) For Group 1 airplanes: After replacement of each affected part on an airplane as specified in paragraph (h) of this AD. \n\t(2) For Group 2 airplanes: As of theeffective date of this AD. \n\n(j) Other FAA AD Provisions \n\n\n\tThe following provisions also apply to this AD: \n\t(1) Alternative Methods of Compliance (AMOCs): The Manager, Large Aircraft Section, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the Large Aircraft Section, International Validation Branch, send it to the attention of the person identified in paragraph (k)(2) of this AD. Information may be emailed to: 9-AVS-AIR-730-AMOC@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office. \n\t(2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, Large Aircraft Section, International Validation Branch, FAA; or the European Union Aviation Safety Agency (EASA); or BAE Systems (Operations) Limited's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature. \n\n(k) Related Information \n\n\n\t(1) Refer to Mandatory Continuing Airworthiness Information (MCAI) EASA AD 2020-0237, dated October 28, 2020, for related information. This MCAI may be found in the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2021-0138. \n\t(2) For more information about this AD, contact Todd Thompson, Aerospace Engineer, Large Aircraft Section, International Validation Branch, FAA, 2200 South 216th St., Des Moines, WA 98198; telephone and fax: 206-231-3228; email Todd.Thompson@faa.gov. \n\t(3) For service information identified in this AD that is not incorporated by reference, contact BAE Systems (Operations) Limited, Customer Information Department, Prestwick International Airport, Ayrshire, KA9 2RW, Scotland, United Kingdom; telephone +44 1292 675207; fax +44 1292 675704; email RApublications@baesystems.com; internet http://www.baesystems.com. \n\n(l) Material Incorporated by Reference \n\n\n\tNone. \n\n\n\tIssued on May 7, 2021. Gaetano A. Sciortino, Deputy Director for Strategic Initiatives, Compliance & Airworthiness Division, Aircraft Certification Service. (FR Doc. 2021-10068 Filed 5-12-21; 8:45 am) \n\n1

Background \n\n\n\tThe European Union Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Union, has issued EASA AD 2020-0237, dated October 28, 2020 (EASA AD 2020-0237) (also referred to as the Mandatory Continuing Airworthiness Information, or the MCAI), to correct an unsafe condition for all BAE Systems (Operations) Limited Model BAe 146 and Model Avro 146-RJ series airplanes. You may examine the MCAI in the AD docket at https://www.regulations.gov by searching for and locating Docket No. FAA-2021-0138. \n\tThe FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to all BAE Systems (Operations) Limited Model BAe 146 and Model Avro 146-RJ series airplanes. The NPRM published in the Federal Register on March 15, 2021 (86 FR 14283). The NPRM was prompted by a report indicating that during a routine battery capacity check on the emergency light power units, the PCBs for certain power units were found to show signs of burning. The NPRM proposed to require replacing each Honeywell emergency light power unit having a certain part number with a serviceable emergency light power unit. The FAA is issuing this AD to address heat damage of the PCBs, which could lead to battery discharge and possibly result in lack of power supply to the emergency light units when needed. See the MCAI for additional background information. \n\nComments \n\n\n\tThe FAA gave the public the opportunity to participate in developing this final rule. The FAA received no comments on the NPRM or on the determination of the cost to the public. \n\nConclusion \n\n\n\tThe FAA reviewed the relevant data and determined that air safety and the public interest require adopting this final rule as proposed, except for minor editorial changes. The FAA has determined that these minor changes: ? Are consistent with the intent that was proposed in the NPRM for addressing the unsafe condition;and ? Do not add any additional burden upon the public than was already proposed in the NPRM. \n\nCosts of Compliance \n\n\n\tThe FAA estimates that this AD affects 30 airplanes of U.S. registry. The FAA estimates the following costs to comply with this AD: \n\nEstimated Costs for Required Actions Labor cost Parts cost Cost per product Cost on U.S. operators 2 work-hours × $85 per hour = $170 $1,800 $1,970 $59,100 \n\nAuthority for This Rulemaking \n\n\n\tTitle 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority. \n\tThe FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: General requirements. Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action. \n\nRegulatory Findings \n\n\n\tThis AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. \n\tFor the reasons discussed above, I certify that this AD: \n\t(1) Is not a "significant regulatory action" under Executive Order 12866, \n\t(2) Will not affect intrastate aviation in Alaska, and \n\t(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. \n\nList of Subjects in 14 CFR Part 39 \n\n\n\tAir transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.