AD 2020-07-12

The FAA is adopting a new airworthiness directive (AD) for certain ATR--GIE Avions de Transport R(eacute)gional Model ATR42-500 airplanes. This AD was prompted by a report of interference between bonding braid screws and pitch tab control rods on the ATR final assembly line. This AD requires an inspection of the bonding braid screws for proper installation, a detailed inspection for damage to the pitch tab control rods if necessary, and replacement of the pitch tab control rods if necessary, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.

Final rule.

Adoption of the Amendment \n\n\n\tAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n0 1. The authority citation for part 39 continues to read as follows: \n\n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\n\n\nSec. 39.13 (Amended) \n\n0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD): \n\n2020-07-12 ATR--GIE Avions de Transport R(eacute)gional: Amendment 39-19891; Docket No. FAA-2019-0985; Product Identifier 2019-NM-183- AD. \n\n(a) Effective Date \n\n\n\tThis AD is effective May 18, 2020. \n\n(b) Affected ADs \n\n\n\tNone. \n\n(c) Applicability \n\n\n\tThis AD applies to ATR--GIE Avions de Transport R(eacute)gional Model ATR42-500 airplanes, certificated in any category, as identified in European Union Aviation Safety Agency (EASA) AD 2019- 0262, dated October 22, 2019 (''EASA AD 2019-0262''). \n\n(d) Subject \n\n\n\tAir Transport Association(ATA) of America Code 27, Flight controls. \n\n(e) Reason \n\n\n\tThis AD was prompted by a report of interference between bonding braid screws and pitch tab control rods on the ATR final assembly line. The FAA is issuing this AD to address interference between bonding braid screws and pitch tab control rods, which could lead to failure of the rods and tab disconnection, possibly resulting in reduced control of the airplane. \n\n(f) Compliance \n\n\n\tComply with this AD within the compliance times specified, unless already done. \n\n(g) Requirements \n\n\n\tExcept as specified in paragraph (h) of this AD: Comply with all required actions and \n\n((Page 20413)) \n\ncompliance times specified in, and in accordance with, EASA AD 2019- 0262. \n\n(h) Exceptions to EASA AD 2019-0262 \n\n\n\t(1) Where EASA AD 2019-0262 refers to its effective date, this AD requires using the effective date of this AD. \n\t(2) The ''Remarks'' section of EASA AD 2019-0262 does not apply to this AD. \n\n(i) No Reporting Requirement \n\n\n\tAlthough the service information referenced in EASA AD 2019-0262 specifies to submit certain information to the manufacturer, this AD does not include that requirement. \n\n(j) Other FAA AD Provisions \n\n\n\tThe following provisions also apply to this AD: \n\t(1) Alternative Methods of Compliance (AMOCs): The Manager, International Section, Transport Standards Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Section, send it to the attention of the person identified in paragraph (k) of this AD. Information may be emailed to: 9-ANM-116-AMOC-REQUESTS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standardsdistrict office/certificate holding district office. \n\t(2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, International Section, Transport Standards Branch, FAA; or EASA; or ATR--GIE Avions de Transport R(eacute)gional's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature. \n\n(k) Related Information \n\n\n\tFor more information about this AD, contact Shahram Daneshmandi, Aerospace Engineer, International Section, Transport Standards Branch, FAA, 2200 South 216th St., Des Moines, WA 98198; telephone and fax 206-231-3220. \n\n(l) Material Incorporated by Reference \n\n\n\t(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. \n\t(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise. \n\t(i) European Union Aviation Safety Agency (EASA) AD 2019-0262, dated October 22, 2019. \n\t(ii) (Reserved) \n\t(3) For information about EASA AD 2019-0262, contact the EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; telephone +49 221 89990 6017; email ADs@easa.europa.eu; internet www.easa.europa.eu. You may find this EASA AD on the EASA website at https://ad.easa.europa.eu. \n\t(4) You may view this material at the FAA, Transport Standards Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. This material may be found in the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA- 2019-0985. \n\t(5) You may view this material that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email fedreg.legal@nara.gov, or go to: https://www.archives.gov/federal-register/cfr/ibr-locations.html. \n\n\n\tIssued on April 3, 2020. Lance T. Gant, Director, Compliance & Airworthiness Division, Aircraft Certification Service. (FR Doc. 2020-07647 Filed 4-10-20; 8:45 am) \n\tBILLING CODE 4910-13-P

Discussion \n\n\n\tThe EASA, which is the Technical Agent for the Member States of the European Union, has issued EASA AD 2019-0262, dated October 22, 2019 (''EASA AD 2019-0262'') (also referred to as the Mandatory Continuing Airworthiness Information, or ''the MCAI''), to correct an unsafe condition for certain ATR--GIE Avions de Transport R(eacute)gional Model ATR42-500 airplanes. \n\tThe FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to certain ATR--GIE Avions de Transport R(eacute)gional Model ATR42-500 airplanes. The NPRM published in the Federal Register on December 19, 2019 (84 FR 69662). The NPRM was prompted by a report of interference between bonding braid screws and pitch tab control rods on the ATR final assembly line. The NPRM proposed to require an inspection of the bonding braid screws for proper installation, a detailed inspection for damage to the pitch tab control rods if necessary, and replacement of the pitch tab control rods if necessary. \n\tThe FAA is issuing this AD to address interference between bonding braid screws and pitch tab control rods, which could lead to failure of the rods and tab disconnection, possibly resulting in reduced control of the airplane. See the MCAI for additional background information. \n\nComments \n\n\n\tThe FAA gave the public the opportunity to participate in developing this final rule. The following presents the comment received on the NPRM and the FAA's response to the comment. \n\nRequest To Allow Credit for Work Done Using Alternative Service Information \n\n\n\tSilver Airways requested credit for accomplishment of the proposed requirements on its current fleet of affected ATR42 airplanes using alternative service information, i.e., by accomplishment of ATR All Operator Message (AOM) 2019/09, Issue 2, and compliance with ATR Service Bulletin ATR42-27-0112, dated August 6, 2019, referencing EASA AD 2019-0262. \n\tThe FAA disagrees with the request because the commenter provided no justification. The FAA has determined that in order to address the identified unsafe condition, operators must comply with the requirements of EASA AD 2019-0262, except as specified in paragraph (h) of this AD. EASA AD 2019-0262 specifies only ATR Service Bulletin ATR42-27-0112 for compliance actions, and it does not specify an AOM. However, under the provisions of paragraph (j) of this AD, the FAA will consider requests for approval to use alternative service information if sufficient data are submitted to substantiate that the actions specified in the alternative service information would provide an acceptable level of safety. The FAA has not changed this AD with regard to this request. \n\n((Page 20412)) \n\nConclusion \n\n\n\tThe FAA reviewed the relevant data, considered the comment received, and determined that air safety and the public interest require adopting this final rule as proposed, except for minor editorial changes. The FAA has determined that these minor changes: \n\tAre consistent with the intent that was proposed in the NPRM for addressing the unsafe condition; and \n\tDo not add any additional burden upon the public than was already proposed in the NPRM. \n\nRelated IBR Material Under 1 CFR Part 51 \n\n\n\tEASA AD 2019-0262 describes procedures for inspecting the bonding braid screws for proper installation, doing a detailed inspection for damage of the pitch tab control rods, and replacing the pitch tab control rods. This material is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section. \n\nCosts of Compliance \n\n\n\tThe FAA estimates that this AD affects 3 airplanes of U.S. registry. The FAA estimates the following costs to comply with this AD: \n\n\n\tEstimated Costs for Required Actions ---------------------------------------------------------------------------------------------------------------- \n\tCost per Cost on U.S. \n\tLabor cost Parts cost product operators ---------------------------------------------------------------------------------------------------------------- 1 work-hour x $85 per hour = $85............................. $0 $85 $255 ---------------------------------------------------------------------------------------------------------------- \n\n\n\tThe FAA estimates the following costs to do any necessary on- condition actions that would be required based on the results of any required actions. The FAA has no way of determining the number of aircraft that might need these on-condition actions: \n\n\n\tEstimated Costs of On-Condition Actions ------------------------------------------------------------------------ \n\tCost per \n\tLabor cost Parts cost product ------------------------------------------------------------------------ 1 work-hour x $85 per hour = $85...... $11,940 $12,025 ------------------------------------------------------------------------ \n\nAuthority for This Rulemaking \n\n\n\tTitle 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority. \n\tThe FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: ''General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action. \n\nRegulatory Findings \n\n\n\tThis AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. \n\tFor the reasons discussed above, I certify that this AD: \n\t(1) Is not a ''significant regulatory action'' under Executive Order 12866, \n\t(2) Will not affect intrastate aviation in Alaska, and \n\t(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. \n\nList of Subjects in 14 CFR Part 39 \n\n\n\tAir transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.