AD 2019-19-04

The FAA is adopting a new airworthiness directive (AD) for all Saab AB, Saab Aeronautics Model SAAB 2000 airplanes. This AD was prompted by reports of cracks in the o-ring groove of magnetic fuel level indicators. This AD requires a one-time detailed inspection of the magnetic fuel level indicator for cracks and replacement of cracked magnetic fuel level indicators. The FAA is issuing this AD to address the unsafe condition on these products.

Final rule.

Adoption of the Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0 1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD):

2019-19-04 Saab AB, Saab Aeronautics (Formerly Known as Saab AB, Saab Aerosystems): Amendment 39-19740; Docket No. FAA-2019-0521; Product Identifier 2019-NM-047-AD.

(a) Effective Date

This AD is effective October 31, 2019.

(b) Affected ADs

None.

(c) Applicability

This AD applies to Saab AB, Saab Aeronautics Model SAAB 2000 airplanes, certificated in any category, all manufacturer serial numbers.

(d) Subject

Air Transport Association (ATA) of America Code 28, Fuel.

(e) Reason

This AD was prompted by reports of cracks in the o-ring groove of magnetic fuel level indicators. The FAA is issuing this AD to address this condition, which, if not detected and corrected, could result in a severe fuel leak and consequent risk of fuel starvation.

(f) Compliance

Comply with this AD within the compliance times specified, unless already done.

(g) Definitions

(1) For the purposes of this AD, an affected part is any magnetic fuel level indicator having part number 35081587.
(2) For the purposes of this AD, a serviceable part is an affected part that is new (not previously installed); or an affected part that, before installation, has passed an inspection in accordance with the instructions of Saab Service Bulletin 2000-28- 027, dated January 15, 2019.

(h) Inspection

Within 3,000 flight hours or 24 months, whichever occurs first after the effective date of this AD, remove and perform a one-time detailed inspection of each affected part for cracks in accordance with the Accomplishment Instructions of Saab Service Bulletin 2000- 28-027, dated January 15, 2019.

(i) Corrective Action

If, during the inspection required by paragraph (h) of this AD, any crack is detected on an affected part, before further flight, replace that affected part with a serviceable part in accordance with the Accomplishment Instructions of Saab Service Bulletin 2000- 28-027, dated January 15, 2019.

(j) No Parts Return

Although Saab Service Bulletin 2000-28-027, dated January 15, 2019, specifies to return faulty parts to the manufacturer, this AD does not require returning the faulty parts to the manufacturer.

(k) Parts Installation Limitation

As of the effective date of this AD, installation of an affected part is allowed on an airplane, provided it is a serviceable part as defined in paragraph (g)(2) of this AD.

(l) Other FAA AD Provisions

The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, International Section, Transport Standards Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Section, send it to the attention of the person identified in paragraph (m)(2) of this AD. Information may be emailed to: 9-ANM-116-AMOC-REQUESTS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal

[[Page 50727]]

inspector, the manager of the local flight standards district office/certificate holding district office.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, International Section, Transport Standards Branch, FAA; or the European Union Aviation Safety Agency (EASA); or Saab AB, Saab Aeronautics's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature.

(m) Related Information

(1) Refer to Mandatory Continuing Airworthiness Information (MCAI) EASA AD 2019-0053, dated March 14, 2019, for related information. This MCAI may be found in the AD docket on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2019-0521.
(2) For more information about this AD, contact Shahram Daneshmandi, Aerospace Engineer, International Section, Transport Standards Branch, FAA, 2200 South 216th St., Des Moines, WA 98198; telephone and fax 206-231-3220.

(n) Material Incorporated by Reference

(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.
(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise.
(i) Saab Service Bulletin 2000-28-027, dated January 15, 2019.
(ii) [Reserved]
(3) For service information identified in this AD, contact Saab AB, Saab Aeronautics, SE-581 88, Link[ouml]ping, Sweden; telephone +46 13 18 5591; fax +46 13 18 4874; email saab2000.techsupport@saabgroup.com; internet http://www.saabgroup.com.
(4) You may view this service information at the FAA, Transport Standards Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195.
(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email fedreg.legal@nara.gov, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.

Discussion

The European Union Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Union, has issued EASA AD 2019-0053, dated March 14, 2019 (referred to after this as the Mandatory Continuing Airworthiness Information, or ``the MCAI''), to correct an unsafe condition for all Saab AB, Saab Aeronautics Model SAAB 2000 airplanes.
The FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to all Saab AB, Saab Aeronautics Model SAAB 2000 airplanes. The NPRM published in the Federal Register on July 3, 2019 (84 FR 31775). The NPRM was prompted by reports of cracks in the o-ring groove of magnetic fuel level indicators. The NPRM proposed to require a one-time detailed inspection of the magnetic fuel level indicator for cracks and replacement of cracked magnetic fuel level indicators.
The FAA is issuing this AD to address cracks in the o-ring groove of magnetic fuel level indicators, which, if not detected and corrected, could result in a severe fuel leak and consequent risk of fuel starvation. See the MCAI for additional background information.

Comments

The FAA gave the public the opportunity to participate in developing this final rule. The FAA received no comments on the NPRM or on the determination of the cost to the public.

Conclusion

The FAA reviewed the relevant data and determined that air safety and the public interest require adopting this final rule as proposed, except for minor editorial changes. The FAA has determined that these minor changes:
Are consistent with the intent that was proposed in the NPRM for addressing the unsafe condition; and
Do not add any additional burden upon the public than was already proposed in the NPRM.

Related Service Information Under 1 CFR Part 51

Saab AB, Saab Aeronautics (Formerly Known as Saab AB, Saab Aerosystems) has issued Service Bulletin 2000-28-027, dated January 15, 2019. This service information describes procedures for a one-time detailed inspection of the magnetic fuel level indicator for cracks and replacement of cracked magnetic fuel level indicators. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.

Costs of Compliance

The FAA estimates that this AD affects 11 airplanes of U.S. registry. The agency estimates the following costs to comply with this AD:

Estimated Costs for Required Actions ----------------------------------------------------------------------------------------------------------------
Cost per Cost on U.S.
Labor cost Parts cost product operators ---------------------------------------------------------------------------------------------------------------- 6 work-hours x $85 per hour = $510........................... $0 $510 $5,610 ----------------------------------------------------------------------------------------------------------------

[[Page 50726]]

The agency estimates the following costs to do any necessary on- condition action that would be required based on the results of any required actions. The agency has no way of determining the number of aircraft that might need this on-condition action:

Estimated Costs of On-Condition Actions ------------------------------------------------------------------------
Cost per
Labor cost Parts cost product ------------------------------------------------------------------------ 2 work-hours x $85 per hour = $170.... $20,000 $20,170 ------------------------------------------------------------------------

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.
The FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: ``General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
This AD is issued in accordance with authority delegated by the Executive Director, Aircraft Certification Service, as authorized by FAA Order 8000.51C. In accordance with that order, issuance of ADs is normally a function of the Compliance and Airworthiness Division, but during this transition period, the Executive Director has delegated the authority to issue ADs applicable to transport category airplanes and associated appliances to the Director of the System Oversight Division.

Regulatory Findings

This AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
(1) Is not a ``significant regulatory action'' under Executive Order 12866,
(2) Will not affect intrastate aviation in Alaska, and
(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.