AD 2018-19-27

We are adopting a new airworthiness directive (AD) for certain Dassault Aviation Model FALCON 2000EX airplanes. This AD was \n\n((Page 50480)) \n\nprompted by the manufacturer revising the airplane maintenance manual (AMM) maintenance requirements and airworthiness limitations. This AD requires revising the maintenance or inspection program, as applicable, to incorporate new maintenance requirements and airworthiness limitations. We are issuing this AD to address the unsafe condition on these products.

Final rule.

Adoption of the Amendment \n\n\n\tAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n0 1. The authority citation for part 39 continues to read as follows: \n\n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\n\n\nSec. 39.13 (Amended) \n\n0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD): \n\n2018-19-27 Dassault Aviation: Amendment 39-19428; Docket No. FAA- 2018-0357; Product Identifier 2018-NM-035-AD. \n\n(a) Effective Date \n\n\n\tThis AD is effective November 13, 2018. \n\n(b) Affected ADs \n\n\n\tThis AD affects AD 2010-26-05, Amendment 39-16544 (75 FR 79952, December 21, 2010) (''AD 2010-26-05''); and AD 2014-16-12, Amendment 39-17936 (79 FR 52187, September 3, 2014) (''AD 2014-16-12''). \n\n(c) Applicability \n\n\n\tThis AD applies to Dassault Aviation Model FALCON 2000EX airplanes, certificated in any category, with an original certificateof airworthiness or original export certificate of airworthiness issued on or before January 15, 2018. \n\n(d) Subject \n\n\n\tAir Transport Association (ATA) of America Code 05, Time limits/ maintenance checks. \n\n(e) Reason \n\n\n\tThis AD was prompted by manufacturer revisions to the airplane maintenance manual (AMM) that introduce new or more restrictive maintenance requirements and airworthiness limitations. We are issuing this AD to address reduced structural integrity of the airplane. \n\n(f) Compliance \n\n\n\tComply with this AD within the compliance times specified, unless already done. \n\n(g) Revision of Maintenance or Inspection Program \n\n\n\tWithin 90 days after the effective date of this AD, revise the maintenance or inspection program, as applicable, to incorporate the information specified in Chapter 5-40, Airworthiness Limitations, DGT 113877, Revision 11, dated November 2017, of the Dassault Falcon 2000EX Maintenance Manual. The initial compliance times for doing thetasks are at the time specified in Chapter 5-40, Airworthiness Limitations, DGT 113877, Revision 11, dated November 2017, of the Dassault Falcon 2000EX Maintenance Manual, or within 90 days after the effective date of this AD, whichever occurs later; except for task number 52-20-00-610-801-01, the initial compliance time is within 24 months after October 8, 2014 (the effective date of AD 2014-16-12). The term ''LDG'' in the ''First Inspection'' column of any table in Chapter 5-40, Airworthiness Limitations, DGT 113877, Revision 11, dated November 2017, means total airplane landings. The term ''FH'' in the ''First Inspection'' column of any table in Chapter 5-40, Airworthiness Limitations, DGT 113877, Revision 11, dated November 2017, means total flight hours. The term ''FC'' in the ''First Inspection'' column of any table in Chapter 5-40, Airworthiness Limitations, DGT 113877, Revision 11, dated November 2017, means total flight cycles. \n\n(h) No Alternative Actions or IntervalsAfter the maintenance or inspection program has been revised as required by paragraph (g) of this AD, no alternative actions (e.g., inspections) or intervals may be used unless the actions or intervals are approved as an alternative method of compliance (AMOC) in accordance with the procedures specified in paragraph (j)(1) of this AD. \n\n(i) Terminating Actions for Other ADs \n\n\n\t(1) Accomplishing the actions required by paragraph (g) of this AD terminates all of the requirements of AD 2014-16-12. \n\t(2) Accomplishing the actions specified in paragraph (g) of this AD terminates the requirements of paragraph (g) of AD 2010-26-05 for Dassault Aviation Model FALCON 2000EX airplanes. \n\n(j) Other FAA AD Provisions \n\n\n\tThe following provisions also apply to this AD: \n\t(1) Alternative Methods of Compliance (AMOCs): The Manager, International Section, Transport Standards Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Section, send it to the attention of the person identified in paragraph (k)(2) of this AD. Information may be emailed to: 9-ANM-116-AMOC-REQUESTS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. \n\t(2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, International Section, Transport Standards Branch, FAA; or the European Aviation Safety Agency (EASA); or Dassault Aviation's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature. \n\n(k)Related Information \n\n\n\t(1) Refer to Mandatory Continuing Airworthiness Information (MCAI) EASA AD 2018-0021, dated January 29, 2018, for related information. This MCAI may be found in the AD docket on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2018-0357. \n\t(2) For more information about this AD, contact Tom Rodriguez, Aerospace Engineer, International Section, Transport Standards Branch, FAA, 2200 South 216th St., Des Moines, WA 98198; telephone and fax 206-231-3226. \n\n(l) Material Incorporated by Reference \n\n\n\t(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. \n\t(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise. \n\t(i) Chapter 5-40, Airworthiness Limitations, DGT 113877, Revision 11, dated \n\n((Page 50482)) \n\nNovember 2017, of the Dassault Falcon 2000EX Maintenance Manual. \n\t(ii) Reserved. \n\t(3) For service information identified in this AD, contact Dassault Falcon Jet Corporation, Teterboro Airport, P.O. Box 2000, South Hackensack, NJ 07606; telephone 201-440-6700; internet http://www.dassaultfalcon.com. \n\t(4) You may view this service information at the FAA, Transport Standards Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. \n\t(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.

Discussion \n\n\n\tWe issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to certain Dassault Aviation Model FALCON 2000EX airplanes. The NPRM published in the Federal Register on April 30, 2018 (83 FR 18760). The NPRM was prompted by the manufacturer revising the AMM maintenance requirements and airworthiness limitations. The NPRM proposed to require revising the maintenance or inspection program, as applicable, to incorporate new maintenance requirements and airworthiness limitations. We are issuing this AD to address reduced structural integrity of the airplane. \n\tThe European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Union, has issued EASA Airworthiness Directive 2018-0021, dated January 29, 2018 (referred to after this as the Mandatory Continuing Airworthiness Information, or ''the MCAI''), to correct an unsafe condition for certain Dassault Aviation Model FALCON 2000EX airplanes. The MCAI states: \n\n\n\tThe airworthiness limitations for Dassault Falcon 2000EX aeroplanes, which are approved by EASA, are currently defined and published in Aircraft Maintenance Manual (AMM) Airworthiness Limitations Section (ALS) Chapter 5-40. These instructions have been identified as mandatory for continued airworthiness. \n\tFailure to accomplish these instructions could result in an unsafe condition (i.e., reduced structural integrity of the airplane). \n\tEASA previously issued (EASA) AD 2012-0157 (which corresponds to FAA AD 2014-16-12, Amendment 39-17936 (79 FR 52187, September 3, 2014) (''AD 2014-16-12'')), requiring the actions described in Dassault Falcon 2000EX AMM Chapter 5-40 (DGT 113877) at Revision 07. \n\tSince that (EASA) AD was issued, Dassault published Revision 11 of Dassault Falcon 2000EX AMM Chapter 5-40 (DGT 113877), containing new and/or more restrictive maintenance tasks and introducing (among other changes) an operationaltest for Cursor Control Device. \n\tFor the reason described above, this (EASA) AD retains the requirements of EASA AD 2012-0157, which is superseded, and requires accomplishment of the actions specified in the Dassault Falcon 2000EX AMM Chapter 5-40 (DGT 113877) at Revision 11 * * *. \n\n\n\tYou may examine the MCAI in the AD docket on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2018- 0357. \n\nComments \n\n\n\tWe gave the public the opportunity to participate in developing this final rule. We received no comments on the NPRM or on the determination of the cost to the public. \n\nConclusion \n\n\n\tWe reviewed the relevant data and determined that air safety and the public interest require adopting this final rule as proposed, except for minor editorial changes. We have determined that these minor changes: \n\tAre consistent with the intent that was proposed in the NPRM for addressing the unsafe condition; and \n\tDo not add any additional burdenupon the public than was already proposed in the NPRM. \n\nRelated Service Information Under 1 CFR Part 51 \n\n\n\tDassault Aviation has issued Chapter 5-40, Airworthiness Limitations, DGT 113877, Revision 11, dated November 2017, of the Dassault Falcon 2000EX Maintenance Manual. This service information describes instructions applicable to airworthiness and safe life limitations. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section. \n\nCosts of Compliance \n\n\n\tWe estimate that this AD affects 181 airplanes of U.S. registry. \n\tWe estimate the following costs to comply with this AD: \n\tWe have determined that revising the maintenance or inspection program takes an average of 90 work-hours per operator, although we recognize that this number may vary from operator to operator. In the past, we have estimated that this action takes 1 work-hour per airplane. Since operators incorporate maintenance or inspection program changes for their affected fleet(s), we have determined that a per- operator estimate is more accurate than a per-airplane estimate. Therefore, we estimate the total cost per operator to be $7,650 (90 work-hours x $85 per work-hour). \n\nAuthority for This Rulemaking \n\n\n\tTitle 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority. \n\tWe are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: ''General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition \n\n((Page 50481)) \n\nthat is likely to exist or develop on products identified in this rulemaking action. \n\tThis AD is issued in accordance with authority delegated by the Executive Director, Aircraft Certification Service, as authorized by FAA Order 8000.51C. In accordance with that order, issuance of ADs is normally a function of the Compliance and Airworthiness Division, but during this transition period, the Executive Director has delegated the authority to issue ADs applicable to transport category airplanes and associated appliances to the Director of the System Oversight Division. \n\nRegulatory Findings \n\n\n\tThis AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levelsof government. \n\tFor the reasons discussed above, I certify that this AD: \n\t(1) Is not a ''significant regulatory action'' under Executive Order 12866, \n\t(2) Is not a ''significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979), \n\t(3) Will not affect intrastate aviation in Alaska, and \n\t(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. \n\nList of Subjects in 14 CFR Part 39 \n\n\n\tAir transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.