Adoption of the Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0 1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
0 2. The FAA amends Sec. 39.13 by removing Airworthiness Directive (AD) 2018-03-03, Amendment 39-19176 (83 FR 6114, February 13, 2018) and adding the following new AD:
2018-03-03 R1 Textron Aviation Inc.: Amendment 39-19276; Docket No. FAA-2018-0068; Product Identifier 2017-CE-049-AD.
(a) Effective Date
This AD is effective May 23, 2018.
(b) Affected ADs
This AD replaces Airworthiness Directive (AD) 2018-03-03, Amendment 39-19176 (83 FR 6114, February 13, 2018) (``AD 2018-03- 03'').
(c) Applicability
This AD applies to the following Textron Aviation Inc. (type certificate previously held by Cessna Aircraft Company) model airplanes, that are certificated in any category: [GRAPHIC] [TIFF OMITTED] TR08MY18.009
[[Page 20722]]
(d) Subject
Joint Aircraft System Component (JASC)/Air Transport Association (ATA) of America Code 53, Fuselage.
(e) Unsafe Condition
This AD was prompted by several reports of confusion in interpreting the compliance times for the initial inspection of the carry through spar cap. We are issuing this AD to eliminate confusion in interpreting the compliance times for this inspection. The unsafe condition related to this AD was previously addressed in AD 2018-03-03.
(f) Compliance
Comply with this AD within the compliance times specified, unless already done.
(g) Inspection Criteria
For the inspections required in paragraphs (h), (i), (j) and (l) of this AD, do a detailed visual inspection of the left and right forward lower carry through spar cap for cracks. Using a 10Xmagnifier visually inspect the bottom surface of the carry through spar cap in the areas around the fasteners located just inboard of the left-hand and right-hand forward lower wing fittings. If a crack is not positively identified during the detailed visual inspection but is suspected or the area is questionable, before further flight, do a surface eddy current inspection of the suspected area. Do these inspections using the Accomplishment Instructions in Textron Aviation Multi-engine Mandatory Service Letter MEL-57-01 and Textron Aviation Conquest Mandatory Service Letter CQL-57-01, both dated December 18, 2017, as applicable.
(h) Initial Inspection for All Affected Airplanes With 24,975 Hours Time-In-Service (TIS) or More on the Carry Through Spar Cap
Within the next 25 hours TIS after February 28, 2018 (the effective date retained from AD 2018-03-03), do an initial detailed visual inspection following the instructions specified in paragraph (g) of this AD.
(i) Initial Inspection for All Affected Airplanes With Less Than 24,975 Hours TIS on the Carry Through Spar Cap
(1) For Models 401, 401A, 401B, 402, 402A, 402B, 402C, 411, 411A, 414, 414A, 421, and 421A airplanes, do an initial detailed visual inspection following the instructions specified in paragraph (g) of this AD at whichever of the compliance times in paragraphs (i)(1)(i) or (ii) of this AD occurs later. See figures 1 and 2 of paragraph (i)(1) of this AD for examples.
(i) Before or upon accumulating 15,000 hours TIS on the carry through spar cap; or
(ii) Within the next 50 hours TIS after February 28, 2018 (the effective date retained from AD 2018-03-03). [GRAPHIC] [TIFF OMITTED] TR08MY18.010
[GRAPHIC] [TIFF OMITTED] TR08MY18.011
(2) For Models 421B and 421C airplanes, do an initial detailed visual inspection following the instructions specified in paragraph (g) of this AD at whichever of the compliance times in paragraphs (i)(2)(i) or (ii) of this AD occurs later.See figures 3 and 4 to paragraph (i)(2) of this AD for examples.
(i) Before or upon accumulating 12,000 hours TIS on the carry through spar cap; or
(ii) Within the next 50 hours TIS after February 28, 2018 (the effective date retained from AD 2018-03-03).
[[Page 20723]]
[GRAPHIC] [TIFF OMITTED] TR08MY18.012
[GRAPHIC] [TIFF OMITTED] TR08MY18.013
(3) For Model 425 airplanes, do an initial detailed visual inspection following the instructions specified in paragraph (g) of this AD at whichever of the compliance times in paragraphs (i)(3)(i) or (ii) of this AD occurs later. See figures 5 and 6 to paragraphs (i)(3) of this AD for examples.
(i) Before or upon accumulating 11,000 TIS on the carry through spar cap; or
(ii) Within the next 50 hours TIS after February 28, 2018 (the effective date retained from AD 2018-03-03). [GRAPHIC] [TIFF OMITTED] TR08MY18.014
[GRAPHIC] [TIFF OMITTED] TR08MY18.015
[[Page 20724]]
(j) Repetitive Inspectionsfor All Affected Airplanes
If no cracks are found during the initial detailed visual inspections or the surface eddy current inspections required in paragraphs (h) and (i) of this AD, repetitively thereafter inspect at intervals not to exceed 50 hours TIS. Inspect following the instructions specified in paragraph (g) of this AD.
(k) Replacement of Carry Through Spar Cap for All Affected Airplanes
If cracks are found during any inspection required in paragraphs (h) through (j) and paragraph (l) of this AD, before further flight, replace the carry through spar cap.
(l) Initial and Repetitive Inspections of Newly Installed Carry Through Spar Cap for All Affected Airplanes
Do the initial and repetitive inspections following the instructions specified in paragraph (g) of this AD at the applicable compliance time in paragraphs (l)(1) through (3) of this AD. If any cracks are found during any inspection required by this paragraph, before further flight, replace the wing carry through spar cap.
(1) For Models 401, 401A, 401B, 402, 402A, 402B, 402C, 411, 411A, 414, 414A, 421, and 421A airplanes, initially inspect before or upon accumulating 15,000 hours TIS on the newly installed carry through spar cap and repetitively thereafter inspect at intervals not to exceed 50 hours TIS.
(2) For Models 421B and 421C airplanes, initially inspect before or upon accumulating 12,000 hours TIS on the newly installed carry through spar cap and repetitively thereafter inspect at intervals not to exceed 50 hours TIS.
(3) For Model 425 airplanes, initially inspect before or upon accumulating 11,000 hours TIS on the newly installed carry through spar cap and repetitively thereafter inspect at intervals not to exceed 50 hours TIS.
(m) Reporting Requirement for All Affected Airplanes
Within 30 days after each inspection required by paragraphs (h) through (j) and paragraph (l) of this AD, report the results of the inspection to the FAA representative identified in paragraph (r) of this AD using the undated Attachment (titled Spar Cap Inspection Results Form and Spar Cap Inspection Results Form Continued) to Textron Aviation Multi-engine Mandatory Service Letter MEL-57-01 and Textron Aviation Conquest Mandatory Service Letter CQL-57-01, both dated December 18, 2017, as applicable. Please identify AD 2018-03- 03 in the subject line if submitted through email.
(n) Installation of Optional Access Panels All Affected Airplanes
Textron Aviation Conquest Service Bulletin CQB-57-01, Textron Aviation Multi-engine Service Bulletin MEB-57-01, and Textron Multi- engine Service Bulletin MEB-57-02, all dated December 20, 2017, provide the manufacturer's optional procedures for installing access panels for easier access to the forward carry through spar cap. This AD does not require installing the access panels, but does not restrict the owner/operator from doing so.
(o) Credit for Actions Done Following Previous Service Information for Affected Airplanes
This AD allows credit for the initial inspection of the forward lower carry through spar cap required in paragraphs (h) and (i) of this AD if done before February 28, 2018 (the effective date retained from AD 2018-03-03), using the following documents:
(1) Models 401, 401A, 401B, 402, 402A, 402B airplanes: Cessna Aircraft Company Model 401/402 Supplemental Inspection Document, Supplemental Inspection Number 57-10-10, dated June 3, 2002.
(2) Model 402C airplanes: Cessna Aircraft Company Model 402C Maintenance Manual, Supplemental Inspection Number 57-10-14, dated June 3, 2002.
(3) Models 411 and 411A airplanes: Cessna Aircraft Company Model 411, Supplemental Inspection Document, Supplemental Inspection Number 57-10-10, dated January 6, 2003.
(4) Model 414 airplanes: Cessna Aircraft Company Model 414 Supplemental Inspection Document, Supplemental Inspection Number 57- 10-10, dated August 1, 2002.
(5) Model 414A airplanes: Cessna AircraftCompany Model 414A Supplemental Inspection Document, Supplemental Inspection Number 57- 10-14, dated August 1, 2002.
(6) Models 421, 421A, and 421B airplanes: Cessna Aircraft Company Model 421 Supplemental Inspection Document, Supplemental Inspection Number 57-10-10, dated March 3, 2003.
(7) Model 421C airplanes: Cessna Aircraft Company Model 421C Supplemental Inspection Document, Supplemental Inspection Number 57- 10-14, dated January 6, 2003.
(p) Paperwork Reduction Act Burden Statement
A federal agency may not conduct or sponsor, and a person is not required to respond to, nor shall a person be subject to a penalty for failure to comply with a collection of information subject to the requirements of the Paperwork Reduction Act unless that collection of information displays a current valid OMB Control Number. The OMB Control Number for this information collection is 2120-0056. Public reporting for this collection of information is estimated to be approximately 15 minutes per response, including the time for reviewing instructions, completing and reviewing the collection of information. All responses to this collection of information are mandatory. Comments concerning the accuracy of this burden and suggestions for reducing the burden should be directed to the FAA at: 800 Independence Ave. SW, Washington, DC 20591, Attn: Information Collection Clearance Officer, AES-200.
(q) Alternative Methods of Compliance (AMOCs)
(1) The Manager, Wichita ACO Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the certification office, send it to the attention of the person identified in paragraph (r) of this AD.
(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.
(r) Related Information
For more information about this AD, contact Bobbie Kroetch, Aerospace Engineer, Wichita ACO Branch, 1801 Airport Road, Room 100, Wichita, Kansas 67209; telephone: (316) 946-4155; fax: (316) 946- 4107; email: bobbie.kroetch@faa.gov or Wichita-COS@faa.gov.
(s) Material Incorporated by Reference
(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.
(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise.
(3) The following service information was approved for IBR on February 28, 2018 (83 FR 6114, February 13, 2018).
(i) Textron Aviation Multi-engine Mandatory Service Letter MEL- 57-01, dated December 18, 2017 (includesthe undated Attachment titled Spar Cap Inspection Results Form and Spar Cap Inspection Results Form Continued).
(ii) Textron Aviation Conquest Mandatory Service Letter CQL-57- 01, dated December 18, 2017 (includes the undated Attachment titled Spar Cap Inspection Results Form and Spar Cap Inspection Results Form Continued).
(4) For Textron Aviation service information identified in this AD, contact Textron Aviation Inc., Textron Aviation Customer Service, One Cessna Blvd., Wichita, Kansas 67215; telephone: (316) 517-5800; email: customercare@txtav.com; internet: www.txtav.com.
(5) You may view this service information at FAA, Policy and Innovation Division, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call (816) 329-4148.
(6) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.
[[Page 20725]]