AD 2018-03-11

We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model CL-600-2C10 (Regional Jet Series 700, 701, & 702) airplanes; Model CL-600-2D15 (Regional Jet Series 705) airplanes; Model CL-600-2D24 (Regional Jet Series 900) airplanes; and Model CL- 600-2E25 (Regional Jet Series 1000) airplanes. This AD was prompted by a report of rudder yoke components that had not been properly inspected at the supplier. This AD requires replacement of the left and right rudder yoke assemblies. We are issuing this AD to address the unsafe condition on these products.

Final rule.

Adoption of the Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0 1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD):

2018-03-11 Bombardier, Inc.: Amendment 39-19184; Docket No. FAA- 2017-0811; Product Identifier 2017-NM-068-AD.

(a) Effective Date

This AD is effective March 19, 2018.

(b) Affected ADs

None.

(c) Applicability

This AD applies to the airplanes identified in paragraphs (c)(1), (c)(2), and (c)(3) of this AD, certificated in any category.
(1) Bombardier, Inc., Model CL-600-2C10 (Regional Jet Series 700, 701, & 702) airplanes, serial number 10343.
(2) Bombardier, Inc., Model CL-600-2D15 (Regional Jet Series 705) airplanes andModel CL-600-2D24 (Regional Jet Series 900) airplanes, serial numbers 15326 through 15370 inclusive.
(3) Bombardier, Inc., Model CL-600-2E25 (Regional Jet Series 1000) airplanes, serial numbers 19041 and 19042.

(d) Subject

Air Transport Association (ATA) of America Code 27, Flight controls.

(e) Reason

This AD was prompted by a report of rudder yoke components that had not been properly inspected at the supplier. We are issuing this AD to prevent a cracked rudder yoke, which may affect rudder function on the affected side and could result in difficulties in maneuvering the airplane.

(f) Compliance

Comply with this AD within the compliance times specified, unless already done.

(g) Replacement of Left and Right Rudder Yoke Assemblies

Within 6,600 flight hours after the effective date of this AD, replace the left and right rudder yoke assemblies, in accordance with the Accomplishment Instructions of Bombardier Service Bulletin 670BA-27-073, dated November 23, 2016.

(h) Other FAA AD Provisions

The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, New York ACO Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the certification office, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO Branch, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone: 516-228-7300; fax: 516-794-5531. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain correctiveactions from a manufacturer, the action must be accomplished using a method approved by the Manager, New York ACO Branch, FAA; or Transport Canada Civil Aviation (TCCA); or Bombardier, Inc.'s TCCA Design Approval Organization (DAO). If approved by the DAO, the approval must include the DAO-authorized signature.

(i) Related Information

(1) Refer to Mandatory Continuing Airworthiness Information (MCAI) Canadian AD CF-2017-10, dated February 27, 2017, for related information. This MCAI may be found in the AD docket on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017-0811.
(2) For more information about this AD, contact Aziz Ahmed, Aerospace Engineer, Airframe and Mechanical Systems Section, FAA, New York ACO Branch, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone: 516-228-7329; fax: 516-794-5531.

(j) Material Incorporated by Reference

(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.
(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise.
(i) Bombardier Service Bulletin 670BA-27-073, dated November 23, 2016.
(ii) Reserved.
(3) For service information identified in this AD, contact Bombardier, Inc., 400 C[ocirc]te Vertu Road West, Dorval, Qu[eacute]bec H4S 1Y9, Canada; Widebody Customer Response Center North America toll-free telephone: 1-866-538-1247 or direct-dial telephone: 1-514-855-2999; fax: 514-855-7401; email: ac.yul@aero.bombardier.com; internet: http://www.bombardier.com.
(4) You may view this service information at the FAA, Transport Standards Branch, 1601 Lind Avenue SW, Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.
(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to certain Bombardier, Inc., Model CL-600-2C10 (Regional Jet Series 700, 701, & 702) airplanes; Model CL-600-2D15 (Regional Jet Series 705) airplanes; Model CL-600- 2D24 (Regional Jet Series 900) airplanes; and Model CL-600-2E25 (Regional Jet Series 1000) airplanes. The NPRM published in the Federal Register on September 13, 2017 (82 FR 42955) (``the NPRM''). The NPRM was prompted by a report of rudder yoke components that had not been properly inspected at the supplier. The NPRM proposed to require replacement of the left and right rudder yoke assemblies. We are issuing this AD to prevent a cracked rudder yoke, which may affect rudder function on the affected side and could result in difficulties in maneuvering the airplane.
Transport Canada Civil Aviation (TCCA), which is the aviation authority for Canada, has issued Canadian ADCF-2017-10, dated February 27, 2017 (referred to after this as the Mandatory Continuing Airworthiness Information, or ``the MCAI''), to correct an unsafe condition for certain Bombardier, Inc., Model CL-600-2C10 (Regional Jet Series 700, 701, & 702) airplanes; Model CL-600-2D15 (Regional Jet Series 705) airplanes; Model CL-600-2D24 (Regional Jet Series 900) airplanes; and Model CL-600-2E25 (Regional Jet Series 1000) airplanes. The MCAI states:

Bombardier Aerospace has informed Transport Canada that a number of rudder yoke components were received which had not been properly inspected at the supplier. The rudder yoke supplier discovered that the crack detection inspection was omitted following the manufacturing of some components. A cracked rudder yoke may affect rudder function on the affected side and could result in difficulties in maneuvering the aeroplane.
This [Canadian] AD was issued to mandate the replacement of the left and right rudder yoke assemblies.

You may examine the MCAI in the AD docket on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017- 0811.

Comments

We gave the public the opportunity to participate in developing this final rule. We considered the comment received. The Air Line Pilots Association, International supported the NPRM.

Conclusion

We reviewed the relevant data, considered the comment received, and determined that air safety and the public interest require adopting this AD as proposed except for minor editorial changes. We have determined that these minor changes:
Are consistent with the intent that was proposed in the NPRM for correcting the unsafe condition; and
Do not add any additional burden upon the public than was already proposed in the NPRM.

Related Service Information Under 1 CFR Part 51

Bombardier, Inc., has issued Service Bulletin 670BA-27-073, dated November 23, 2016. This service information describes procedures for replacement of the left and right rudder yoke assemblies. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.

Costs of Compliance

We estimate that this AD affects 48 airplanes of U.S. registry.
We estimate the following costs to comply with this AD:

Estimated Costs ----------------------------------------------------------------------------------------------------------------
Cost per Cost on U.S.
Action Labor cost Parts cost product operators ---------------------------------------------------------------------------------------------------------------- Replacement of rudder yoke 51 work-hours x $85 Negligible........... $4,335 $208,080
assemblies. per hour = $4,335. ----------------------------------------------------------------------------------------------------------------

According to the manufacturer, some of the costs of this AD may be covered under warranty, thereby reducing the cost impact on affected individuals. We do not control warranty coverage for affected individuals. As a result, we have included all available costs in our cost estimate.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in

[[Page 5901]]

air commerce by prescribing regulations for practices, methods, and proceduresthe Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
This AD is issued in accordance with authority delegated by the Executive Director, Aircraft Certification Service, as authorized by FAA Order 8000.51C. In accordance with that order, issuance of ADs is normally a function of the Compliance and Airworthiness Division, but during this transition period, the Executive Director has delegated the authority to issue ADs applicable to transport category airplanes to the Director of the System Oversight Division.

Regulatory Findings

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power andresponsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
1. Is not a ``significant regulatory action'' under Executive Order 12866,
2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),
3. Will not affect intrastate aviation in Alaska, and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.