AD 2018-01-04

Active

Periodic inspections

Key Information
2018-01-04
Active
January 18, 2018
December 26, 2017
FAA-2017-1181
39-19145
Applicability
["Aircraft"]
["Large Airplane"]
Airbus
A340-211 A340-212 A340-213 A340-311 A340-312 A340-313 A340-541 A340-642
Summary

We are superseding Airworthiness Directive (AD) 2011-04-05, which applied to all Airbus Model A340-200, -300, -500, and -600 series airplanes. AD 2011-04-05 required revising the maintenance or inspection program to incorporate new airworthiness limitation items (ALIs). This new AD was prompted by the revision of certain ALIs, which specify more restrictive instructions or airworthiness limitations. This AD requires contacting the FAA to obtain instructions for addressing the unsafe condition on these products, and doing the actions specified in those instructions. We are issuing this AD to address the unsafe condition on these products.

Action Required

Final rule; request for comments.

Regulatory Text

Adoption of the Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0 1. The authority citation for part 39 continues to read as follows:

[[Page 216]]

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

0 2. The FAA amends Sec. 39.13 by removing airworthiness directive (AD) 2011-04-05, Amendment 39-16605 (76 FR 8612, February 15, 2011), and adding the following new AD:

2018-01-04 Airbus: Amendment 39-19145; Docket No. FAA-2017-1181; Product Identifier 2014-NM-037-AD.

(a) Effective Date

This AD becomes effective January 18, 2018.

(b) Affected ADs

This AD replaces AD 2011-04-05, Amendment 39-16605 (76 FR 8612, February 15, 2011) (``AD 2011-04-05'').

(c) Applicability

This AD applies to the Airbus airplanes specified in paragraphs (c)(1) through (c)(4) of this AD, certificated in any category, all manufacturer serial numbers.
(1) Model A340-211, -212, and -213 airplanes.
(2) Model A340-311, -312, and -313 airplanes.
(3) Model A340-541 airplanes.
(4) Model A340-642 airplanes.

(d) Subject

Air Transport Association (ATA) of America Code 05, Periodic inspections.

(e) Reason

This AD was prompted by the revision of certain airworthiness limitation items (ALIs), which specify more restrictive instructions or airworthiness limitations. We are issuing this AD to prevent the failure of certain life-limited parts, which could result in reduced structural integrity of the airplane.

(f) Compliance

Comply with this AD within the compliance times specified, unless already done.

(g) Required Action(s)

Within 30 days after the effective date of this AD, request instructions from the Manager, International Section, Transport Standards Branch, FAA, to address the unsafe condition specified in paragraph (e) of this AD; and accomplishthe action(s) at the times specified in, and in accordance with, those instructions. Guidance can be found in Mandatory Continuing Airworthiness Information (MCAI) European Aviation Safety Agency (EASA) AD 2014-0009, dated January 8, 2014.

(h) Alternative Methods of Compliance (AMOCs)

The Manager, International Section, Transport Standards Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Section, send it to the attention of the person identified in paragraph (i)(2) of this AD. Information may be emailed to: 9-ANM-116-AMOC-REQUESTS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.

(i) Related Information

(1) Refer to MCAI EASA AD 2014-0009, dated January 8, 2014, for related information. You may examine the MCAI on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017-1181.
(2) For more information about this AD, contact Vladimir Ulyanov, Aerospace Engineer, International Section, Transport Standards Branch, FAA, 1601 Lind Avenue SW, Renton, WA 98057-3356; telephone 425-227-1138; fax 425-227-1149.

(j) Material Incorporated by Reference

None.

Supplementary Information

Discussion

We issued AD 2011-04-05, Amendment 39-16605 (76 FR 8612, February 15, 2011) (``AD 2011-04-05''), which applied to all Airbus Model A340- 200, -300, -500, and -600 series airplanes. AD 2011-04-05 was prompted by a determination that certain steel forgings used to manufacture certain landing gear components were below specification limits, and the introduction of new ALIs. AD 2011-04-05 required revising the maintenance or inspection program to incorporate new ALIs. We issued AD 2011-04-05 to prevent the failure of certain life-limited parts, which could result in reduced structural integrity of the airplane.
Since we issued AD 2011-04-05, we have determined that more restrictive instructions or airworthiness limitations are needed to address the unsafe condition.
The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Union, has issued EASA AD 2014-0009, dated January 8, 2014 (referred to after this as the Mandatory Continuing Airworthiness Information, or ``the MCAI''), to correct an unsafe condition for all Airbus Model A340-200, -300,

[[Page 215]]

-500, and -600 series airplanes. The MCAI states:

The airworthiness limitations for Airbus aeroplanes are currently published in Airworthiness Limitations Section (ALS) documents.
The instructions and airworthiness limitations applicable to the Safe Life Airworthiness Limitation Items (SL ALI) are given in Airbus A330 ALS Part 1 and A340 ALS Part 1, which are approved by EASA.
The revision 07 of Airbus A330 and A340 ALS Part 1 introduces more restrictive instructions and/or airworthiness limitations. Failure to comply with this revision could result in an unsafe condition.
For the reason described above, this [EASA] AD retains the requirements of EASA AD 2012-0179, which is superseded, and requires accomplishment of the actions specified in Airbus A330 or A340 ALS Part 1 revision 07.
Inaddition, this [EASA] AD also supersedes EASA AD 2011-0122-E and EASA AD 2011-0212 [which corresponds to FAA AD 2012-25-12, Amendment 39-17293 (77 FR 75825, December 26, 2012)], whose requirements have been transferred into Airbus A330 and A340 ALS Part 1 revision 07.

You may examine the MCAI on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2017- 1181.

FAA's Determination and Requirements of This AD

This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI. We are issuing this AD because we evaluated all pertinent information and determined the unsafe condition exists and is likely to exist or develop on other products of the same type design.

FAA's Determination of the Effective Date

Since there are currently no domestic operators of this product, we find good cause that notice and opportunity for prior public comment are unnecessary. In addition, for the reason(s) stated above, we find that good cause exists for making this amendment effective in less than 30 days.

Comments Invited

This AD is a final rule that involves requirements affecting flight safety, and we did not precede it by notice and opportunity for public comment. We invite you to send any written relevant data, views, or arguments about this AD. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No. FAA-2017-1181; Product Identifier 2014-NM-037-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this AD. We will consider all comments received by the closing date and may amend this AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this AD.

Costs of Compliance

Currently, there are no affected U.S.-registered airplanes. This AD requires contacting the FAA to obtain instructions for addressing the unsafe condition, and doing the actions specified in those instructions. Based on the actions specified in the MCAI AD, we are providing the following cost estimates for an affected airplane that is placed on the U.S. Register in the future:

Estimated Costs ----------------------------------------------------------------------------------------------------------------
Cost per
Action Labor cost Parts cost product ---------------------------------------------------------------------------------------------------------------- Maintenance or inspection program revision... 1 work-hour x $85 per hour =$0 $85
$85. ----------------------------------------------------------------------------------------------------------------

Authority for this Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified inthis rulemaking action.
This AD is issued in accordance with authority delegated by the Executive Director, Aircraft Certification Service, as authorized by FAA Order 8000.51C. In accordance with that order, issuance of ADs is normally a function of the Compliance and Airworthiness Division, but during this transition period, the Executive Director has delegated the authority to issue ADs applicable to transport category airplanes to the Director of the System Oversight Division.

Regulatory Findings

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
1. Is not a ``significant regulatory action'' under Executive Order 12866;
2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

AD Assistant

Get AI-powered answers about this AD, check applicability, and find compliance steps.

Sign Up to Unlock
Related ADs
2011-04-05 This AD replaces the above
Contact Information

Vladimir Ulyanov, Aerospace Engineer, International Section, Transport Standards Branch, FAA, 1601 Lind Avenue SW, Renton, WA 98057-3356; telephone: 425-227-1138; fax: 425- 227-1149.

References
Federal Register Volume 83, Number 2 (Wednesday, January 3, 2018)
--- - Part 39
Pages 214-216
FAA Documents
ADs Superseded by This AD
AD Number Subject Effective Date Actions
2011-04-05 Life-limited parts 2011-03-02 View