Adoption of the Amendment \n\n\n\tAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n0 1. The authority citation for part 39 continues to read as follows: \n\n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\n\n\nSec. 39.13 (Amended) \n\n0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD): \n\n2017-06-05 The Boeing Company: Amendment 39-18829; Docket No. FAA- 2016-9300; Directorate Identifier 2016-NM-124-AD. \n\n(a) Effective Date \n\n\n\tThis AD is effective May 1, 2017. \n\n(b) Affected ADs \n\n\n\tNone. \n\n(c) Applicability \n\n\n\tThis AD applies to all The Boeing Company Model DC-6, DC-6A, DC- 6B, C-118A, R6D-1, and R6D-1Z airplanes, certificated in any category. \n\n(d) Subject \n\n\n\tAir Transport Association (ATA) of America Code 57, Wings. \n\n(e) Unsafe Condition \n\n\n\tThis AD was prompted by a report of a fuel leak in a Model C- 118A airplane that resulted from a crack in the wing lower skin just inboard of the number 2 nacelle attach angle at wing station 175. We are issuing this AD to detect and correct fatigue cracking in the wing lower skin, which could adversely affect the structural integrity of the wing. \n\n(f) Compliance \n\n\n\tComply with this AD within the compliance times specified, unless already done. \n\n(g) Repetitive Inspections \n\n\n\tExcept as specified in paragraph (i) of this AD: At the applicable time specified in paragraph 1.E., ''Compliance,'' of Boeing Alert Service Bulletin DC6-57A001, dated April 28, 2016, do radiographic, electromagnetic testing high frequency (ETHF), and electromagnetic testing low frequency (ETLF) inspections for cracking of the wing lower skin at station 175, in accordance with the Accomplishment Instructions of Boeing Alert Service Bulletin DC6-57A001, dated April 28, 2016. Repeat the radiographic, ETHF, and ETLF inspections of any unrepaired areas thereafter at the applicable intervals specified in paragraph 1.E., ''Compliance,'' of Boeing Alert Service Bulletin DC6-57A001, dated April 28, 2016. \n\n(h) Repairs \n\n\n\tIf any cracking is found during any inspection required by this AD: Before further flight, repair the cracking using a method approved in accordance with the procedures specified in paragraph (j) of this AD. \n\n(i) Service Information Exception \n\n\n\tWhere paragraph 1.E., ''Compliance,'' of Boeing Alert Service Bulletin DC6-57A001, dated April 28, 2016, specifies a compliance time ''after the original issue date of this service bulletin,'' this AD requires compliance within the specified compliance time after the effective date of this AD. \n\n((Page 15128)) \n\n(j) Alternative Methods of Compliance (AMOCs) \n\n\n\t(1) The Manager, Los Angeles Aircraft Certification Office (ACO), FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the ACO, send it to the attention of the person identified in paragraph (k) of this AD. Information may be emailed to: 9-ANM-LAACO-AMOC-Requests@faa.gov. \n\t(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. \n\t(3) An AMOC that provides an acceptable level of safety may be used for any repair, modification, or alteration required by this AD if it is approved by the Boeing Commercial Airplanes Organization Designation Authorization (ODA) that has been authorized by the Manager, Los Angeles ACO, to make those findings. To be approved, the repair method, modification deviation, or alteration deviation must meet the certification basis of the airplane, and the approval must specifically referto this AD. \n\t(4) For service information that contains steps that are labeled as Required for Compliance (RC), the provisions of paragraphs (j)(4)(i) and (j)(4)(ii) of this AD apply. \n\t(i) The steps labeled as RC, including substeps under an RC step and any figures identified in an RC step, must be done to comply with the AD. If a step or substep is labeled ''RC Exempt,'' then the RC requirement is removed from that step or substep. An AMOC is required for any deviations to RC steps, including substeps and identified figures. \n\t(ii) Steps not labeled as RC may be deviated from using accepted methods in accordance with the operator's maintenance or inspection program without obtaining approval of an AMOC, provided the RC steps, including substeps and identified figures, can still be done as specified, and the airplane can be put back in an airworthy condition. \n\n(k) Related Information \n\n\n\tFor more information about this AD, contact George Garrido, Aerospace Engineer, AirframeBranch, ANM-120L, Los Angeles ACO, FAA, 3960 Paramount Boulevard, Lakewood, CA 90712-4137; phone: 562-627- 5232; fax: 562-627-5210; email: george.garride@faa.gov. \n\n(l) Material Incorporated by Reference \n\n\n\t(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51. \n\t(2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise. \n\t(i) Boeing Alert Service Bulletin DC6-57A001, dated April 28, 2016. \n\t(ii) Reserved. \n\t(3) For Boeing service information identified in this AD, contact Boeing Commercial Airplanes, Attention: Contractual & Data Services (C&DS), 2600 Westminster Blvd., MC 110-SK57, Seal Beach, CA 90740-5600; telephone 562-797-1717; Internet https://www.myboeingfleet.com. \n\t(4) You may view this service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221. \n\t(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.