AD 2016-11-22

We are adopting a new airworthiness directive (AD) for all Fokker Services B.V. Model F.28 Mark 0070 and 0100 airplanes. This AD was prompted by the need for more restrictive airworthiness limitations. This AD requires revising the maintenance or inspection program, as applicable, to incorporate certain maintenance requirement tasks, thresholds, and intervals. We are issuing this AD to reduce the potential for significant failure conditions and consequent loss of controllability of the airplane.

Final rule.

Adoption of the Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0 1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD):

2016-11-22 Fokker Services B.V.: Amendment 39-18549. Docket No. FAA- 2016-0464; Directorate Identifier 2015-NM-046-AD.

(a) Effective Date

This AD is effective July 12, 2016.

(b) Affected ADs

None.

(c) Applicability

This AD applies to Fokker Services B.V. Model F.28 Mark 0070 and 0100 airplanes,

[[Page 36440]]

certificated in any category, all serial numbers.

(d) Subject

Air Transport Association (ATA) of America Code 05, Time Limits/ Maintenance Checks.

(e) Reason

This AD was prompted by the need for more restrictive airworthiness limitations. We are issuing this AD to reduce the potential for significant failure conditions and consequent loss of controllability of the airplane.

(f) Compliance

Comply with this AD within the compliance times specified, unless already done.

(g) Revision of Maintenance or Inspection Program

(1) Within 12 months after the effective date of this AD, revise the maintenance or inspection program, as applicable, to incorporate the certification maintenance requirements (CMR) specified in ``Fokker 70/100 Certification Maintenance Requirements,'' of Fokker Services B.V. Engineering Report, Airworthiness Limitations Section (ALS), SE-473, Issue 11, released January 19, 2015.
(2) Do the applicable initial CMR inspection at the time specified in paragraph (g)(2)(i) or (g)(2)(ii) of this AD, as applicable, as specified in ``Fokker 70/100 Certification Maintenance Requirements,'' of Fokker Services B.V. Engineering Report, ALS, SE-473, Issue 11, released January 19, 2015. If any discrepancy is found during any inspection, repair using a method approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the European Aviation Safety Agency; or Fokker B.V. Service's EASA Design Organization Approval (DOA). Repair any discrepancy before further flight.
(i) For CMR inspection 783100-CM-01: Within 1 year or 3,000 flight hours after the effective date of this AD, whichever occurs first, but not later than 12,000 flight hours after accomplishing Maintenance Review Board (MRB) Task 783100-00-04.
(ii) For CMR inspection 783500-CM-01: Within 1 year or 3,000 flight hours after the effective date of this AD, whichever occurs first, but not later than 10,000 flight hours after accomplishing MRB Task 783100-01-01.

(h) No Alternative Inspections or Inspection Intervals

After accomplishment of the actions specified in paragraph (g)(1) of this AD, no alternative actions (e.g., inspections) and intervals, may be used, unless the actions or intervals are approved as an alternative method of compliance (AMOC) in accordance with the procedures specified in paragraph (i)(1) of this AD.

(i) Other FAA AD Provisions

The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone 425-227-1137; fax 425-227-1149. Information may be emailed to: 9-ANM-116-AMOC-REQUESTS@faa.gov.Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the EASA; or Fokker Services B.V.'s EASA DOA. If approved by the DOA, the approval must include the DOA-authorized signature.

(j) Related Information

Refer to Mandatory Continuing Airworthiness Information (MCAI) EASA Airworthiness Directive 2015-0027, dated February 20, 2015, for related information. This MCAI may be found in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2016-0464.

(k) MaterialIncorporated by Reference

(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.
(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise.
(i) Fokker Services B.V. Engineering Report, Airworthiness Limitations Section (ALS), SE-473, Issue 11, released January 19, 2015.
(ii) Reserved.
(3) For service information identified in this AD, contact Fokker Services B.V., Technical Services Dept., P.O. Box 1357, 2130 EL Hoofddorp, the Netherlands; telephone +31 (0)88-6280-350; fax +31 (0)88-6280-111; email technicalservices@fokker.com; Internet http://www.myfokkerfleet.com.
(4) You may view this service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.

[[Page 36439]]

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to all Fokker Services B.V. Model F.28 Mark 0070 and 0100 airplanes. The NPRM published in the Federal Register on February 18, 2016 (81 FR 8166) (``the NPRM''). The NPRM was prompted by the need for more restrictive airworthiness limitations. The NPRM proposed to require revising the maintenance or inspection program, as applicable, to incorporate certain maintenance requirement tasks, thresholds, and intervals. We are issuing this AD to reduce the potential for significant failure conditions and consequent loss of controllability of the airplane.
The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Union, has issued EASA Airworthiness Directive 2015-0027, dated February 20, 2015 (referred to after this as the Mandatory Continuing Airworthiness Information, or ``the MCAI''), to correct an unsafe condition for all Fokker Services B.V. Model F.28 Mark 0070 and 0100 airplanes. The MCAI states:

Fokker Services published issue 11 of Engineering Report SE-473, containing Certification Maintenance Requirements (CMRs). This report is Part 1 of the Airworthiness Limitations Section (ALS Part 1) of the Instructions for Continued Airworthiness, referred to in Section 06, Appendix 1, of the Fokker 70/100 Maintenance Review Board (MRB) document.
The complete ALS currently consists of:
Part 1--Report SE-473 (CMRs), Part 2--Report SE-623, Airworthiness Limitation Items (ALIs) and Safe Life Items (SLIs), and Part 3--Report SE-672, Fuel ALIs and Critical Design Configuration Control Limitations (CDCCLs).
The instructions contained in those reports have been identified as mandatory actions for continued airworthiness.
For the reasons described above, this [EASA] AD requires implementation of the maintenance actions as specified in ALS Part 1 of the Instructions for Continued Airworthiness, Fokker Services Engineering Report SE-473 at issue 11.

You may examine the MCAI in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2016- 0464.

Comments

We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM or on the determination of the cost to the public.

Changes to Paragraph Reference

We have updated paragraph (h) of this AD. In paragraph (h) of the NPRM, we inadvertently referenced paragraph (g)(2) of the NPRM. Paragraph (h) of this AD has been updated to reference paragraph (g)(1) of this AD.

Conclusion

We reviewed the relevant data, considered the comment received, and determined that air safety and the public interest require adopting this AD with the change described previously and minor editorial changes. We have determined that these minor changes:
Are consistent withthe intent that was proposed in the NPRM for correcting the unsafe condition; and
Do not add any additional burden upon the public than was already proposed in the NPRM.
We also determined that these changes will not increase the economic burden on any operator or increase the scope of this AD.

Related Service Information Under 1 CFR Part 51

We reviewed ``Fokker 70/100 Certification Maintenance Requirements,'' of Fokker Services B.V. Engineering Report, Airworthiness Limitations Section (ALS), SE-473, Issue 11, released January 19, 2015. This service information describes certification maintenance requirements. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.

Costs of Compliance

We estimate that this AD affects 8 airplanes of U.S. registry.
We also estimate that it takes about 1 work-hour per product to comply withthe basic requirements of this AD. The average labor rate is $85 per work-hour. Based on these figures, we estimate the cost of this AD on U.S. operators to be $680, or $85 per product.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist ordevelop on products identified in this rulemaking action.

Regulatory Findings

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
1. Is not a ``significant regulatory action'' under Executive Order 12866;
2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporationby reference, Safety.