AD 2015-26-05

We are adopting a new airworthiness directive (AD) for all Fokker Services B.V. Model F.28 Mark

[[Page 1875]]

1000, 2000, 3000, and 4000 airplanes. This AD was prompted by a design review, which revealed that no controlled bonding provisions are present on a number of critical locations outside the fuel tank. This AD requires installing additional and improved fuel system bonding provisions, and revising the airplane maintenance or inspection program, as applicable, by incorporating fuel airworthiness limitation items and critical design configuration control limitations. We are issuing this AD to prevent an ignition source in the fuel tank vapor space, which could result in a fuel tank explosion and consequent loss of the airplane.

Final rule.

Adoption of the Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0 1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD):

2015-26-05 Fokker Services B.V.: Amendment 39-18353. Docket No. FAA- 2015-1982; Directorate Identifier 2014-NM-108-AD.

(a) Effective Date

This AD becomes effective February 18, 2016.

(b) Affected ADs

None.

(c) Applicability

This AD applies to Fokker Services B.V. Model F.28 Mark 1000, 2000, 3000, and 4000 airplanes, certificated in any category, all serial numbers.

(d) Subject

Air Transport Association (ATA) of America Code 28, Fuel.

(e) Reason

This AD was prompted by a design review, which revealed that no controlled bonding provisions are present on a number of critical locations outside the fuel tank. We are issuing this AD to prevent an ignition source in the fuel tank vapor space, which could result in a fuel tank explosion and consequent loss of the airplane.

(f) Compliance

Comply with this AD within the compliance times specified, unless already done.

(g) Installation of Bonding Provisions

Within 24 months after the effective date of this AD, install additional and improved fuel system bonding provisions, in accordance with the Accomplishment Instructions of Fokker F28 Appendix SB SBF28-28-059/APP01, dated July 15, 2014, of Fokker F28 Proforma Service Bulletin SBF28-28-059, Revision 1, dated July 15, 2014.

(h) Revision of Maintenance or Inspection Program

At the later of the times specified in paragraphs (h)(1) and (h)(2) of this AD: Revise the airplane maintenance or inspection program, as applicable, by incorporating the fuel airworthiness limitation items and critical design configuration control limitations (CDCCLs) specified in paragraph 1.L.(1)(b) of Fokker F28 Appendix SB SBF28-28-059/APP01, dated July 15, 2014, of Fokker F28 Proforma Service Bulletin SBF28-28-059, Revision 1, dated July 15, 2014.
(1) Before further flight, after accomplishing the installation required by paragraph (g) of this AD.
(2) Within 30 days after the effective date of this AD.

(i) No Alternative Actions, Intervals, and/or CDCCLs

After incorporating the revision required by paragraph (h) of this AD, no alternative actions (e.g., inspections), intervals, or CDCCLs may be used unless the actions, intervals, or CDCCLs are approved as an alternative method of compliance (AMOC) in accordance with the procedures specified in paragraph (j)(1) of this AD.

(j) Other FAA AD Provisions

The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone 425-227-1137; fax 425-227-1149. Information may be emailed to: 9-ANM-116-AMOC-REQUESTS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, theaction must be accomplished using a method approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the European Aviation Safety Agency (EASA); or Fokker B.V. Service's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature.

(k) Related Information

Refer to Mandatory Continuing Airworthiness Information (MCAI) EASA Airworthiness Directive 2014-0109, dated May 8, 2014, for related information. This MCAI may be found in the AD docket on the Internet at http://www.regulations.gov/#!documentDetail;D=FAA-2015- 1982-0002.

(l) Material Incorporated by Reference

(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.
(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise.(i) Fokker F28 Proforma Service Bulletin SBF28-28-059, Revision 1, dated July 15, 2014.
(ii) Fokker F28 Appendix SB SBF28-28-059/APP01, dated July 15, 2014.
(3) For service information identified in this AD, contact Fokker Services B.V., Technical Services Dept., P.O. Box 1357, 2130 EL Hoofddorp, the Netherlands; telephone +31 (0)88-6280-350; fax +31 (0)88-6280-111; email technicalservices@fokker.com; Internet http://www.myfokkerfleet.com.
(4) You may view this service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.
(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to all Fokker Services B.V. Model F.28 Mark 1000, 2000, 3000, and 4000 airplanes. The NPRM published in the Federal Register on June 15, 2015 (80 FR 34106).
The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Union, has issued EASA Airworthiness Directive 2014-0109, dated May 8, 2014 (referred to after this the Mandatory Continuing Airworthiness Information, or ``the MCAI''), to correct an unsafe condition for all Fokker Services B.V. Model F.28 Mark 1000, 2000, 3000, and 4000 airplanes. The MCAI states:

Prompted by an accident * * *, the Federal Aviation Administration (FAA) published Special Federal Aviation Regulation (SFAR) 88 [(66 FR 223086, May 7, 2001)], and the Joint Aviation Authorities (JAA) published Interim Policy INT/POL/25/12.
The review conducted by Fokker Services on the Fokker F28 design, in response to these regulations, revealed that no controlled bonding provisions are present on a number of critical locations outside the fuel tank.
This condition, if not corrected, could create an ignition source in the fuel tank vapour space, possibly resulting in a fuel tank explosions and consequent loss of the aeroplane.
To address this potential unsafe condition, Fokker Services developed a set of fuel tank bonding modifications.
For the reasons described above, this [EASA] AD requires the installation of additional and improved bonding provisions. These modifications do not require opening of the fuel tank access panels.
More information on this subject can be found in Fokker Services All Operators Message AOF28.038#02.

Required actions include revising the airplane maintenance or inspection program, as applicable, by incorporating fuel airworthiness limitation items and critical design configuration control limitations. You may examine the MCAI in the AD docket on the Internet at http://www.regulations.gov/#!documentDetail;D=FAA-2015-1982-0002.

Comments

We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM (80 FR 34106, June 15, 2015) or on the determination of the cost to the public.

Conclusion

We reviewed the relevant data and determined that air safety and the public interest require adopting this AD as proposed except for minor editorial changes. We have determined that these minor changes:
Are consistent with the intent that was proposed in the NPRM (80 FR 34106, June 15, 2015) for correcting the unsafe condition; and
Do not add any additional burden upon the public than was already proposed in the NPRM (80 FR 34106, June 15, 2015).

Related Service Information Under 1 CFR Part 51

Fokker Services B.V. has issued Fokker F28 Appendix SB SBF28-28- 059/APP01, dated July 15, 2014, of Fokker F28 Proforma Service Bulletin SBF28-28-059, Revision 1, dated July 15, 2014. The service information describes procedures for the installation of additional bonding provisions outside the fuel tank. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.

Costs of Compliance

We estimate that this AD affects 5 airplanes of U.S. registry.
We also estimate that it will take about 11 work-hours per product to comply with the basic requirements of this AD. The average labor rate is $85 per work-hour. Required parts will cost about $140 per product. Based on these figures, we estimate the cost of this AD on U.S. operators to be $5,375, or $1,075 per product.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
1. Is not a ``significant regulatory action'' under Executive Order 12866;

[[Page 1876]]

2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov/#!docketDetail;D=FAA-2015-1982; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone 800-647- 5527) is in the ADDRESSES section.List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.