AD 2015-02-09

We are adopting a new airworthiness directive (AD) for Costruzioni Aeronautiche Tecnam srl Model P2006T airplanes. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as cracking found in the engine exhaust pipe. We are issuing this AD to require actions to address the unsafe condition on these products.

Final rule.

Adoption of the Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0 1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

0 2. The FAA amends Sec. 39.13 by adding the following new AD:

2015-02-09 Costruzioni Aeronautiche Tecnam srl: Amendment 39-18076; Docket No. FAA-2014-0876; Directorate Identifier 2014-CE-032-AD.

(a) Effective Date

This airworthiness directive (AD) becomes effective March 5, 2015.

(b) Affected ADs

None.

(c) Applicability

This AD applies to Costruzioni Aeronautiche Tecnam srl P2006T airplanes, all serial numbers, certificated in any category.

(d) Subject

Air Transport Association of America (ATA) Code 78: Engine Exhaust.

(e) Reason

This AD was prompted by mandatory continuing airworthinessinformation (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as cracking found in the engine exhaust pipe. We are issuing this AD to detect and correct cracked engine exhaust pipes, which could lead to engine damage, possibly resulting in damage to the airplane and injury to the occupants.

(f) Actions and Compliance

Unless already done, do the following actions as specified in paragraphs (f)(1) through (f)(3) of this AD:
(1) Within 25 hours time-in-service (TIS) after March 5, 2015 (the effective date of this AD) or within the next 30 days after March 5, 2015 (the effective date of this AD), whichever occurs first, do a detailed inspection of all engine exhaust pipes following the inspection instructions in Costruzioni Aeronautiche TECNAM Service Bulletin No. SB 170-CS-Ed 1, Rev 1, dated September 25, 2014.
(2) If any deformation, cracks, or any other defects are detected during the inspection as required by paragraph (f)(1) of this AD, before further flight, replace the affected pipe with an airworthy part or contact Costruzioni Aeronautiche TECNAM for FAA- approved repair instructions approved specifically for compliance with this AD and incorporate those instructions. Use the information in paragraph (i)(3) of this AD to contact Costruzioni Aeronautiche TECNAM.
(3) Within 30 days after the inspection required by paragraph (f)(1) of this AD or within 30 days after March 5, 2015 (the effective date of this AD), whichever occurs later, report the results (including no findings) by using the occurrence report in Costruzioni Aeronautiche TECNAM Service Bulletin No. SB 170-CS-Ed 1, Rev 1, dated September 25, 2014.

(g) Other FAA AD Provisions

The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, Standards Office, FAA, has the authority to approve AMOCs for this AD,if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Albert Mercado, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4119; fax: (816) 329-4090; email: albert.mercado@faa.gov. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO.
(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.
(3) Reporting Requirements: For any reporting requirement in this AD, a federal agency may not conduct or sponsor, and a person is not required to respond to, nor shall a person be subject to a penalty for failure to comply with a collection of information subject to the requirements of the Paperwork Reduction Act unless that collection of information displays a current valid OMB Control Number. The OMB Control Number for this information collection is 2120-0056. Public reporting for this collection of information is estimated to be approximately 5 minutes per response, including the time for reviewing instructions, completing and reviewing the collection of information. All responses to this collection of information are mandatory. Comments concerning the accuracy of this burden and suggestions for reducing the burden should be directed to the FAA at: 800 Independence Ave. SW., Washington, DC 20591, Attn: Information Collection Clearance Officer, AES-200.

(h) Related Information

Refer to European Aviation Safety Agency (EASA) AD No.: 2014- 0220, dated September 30, 2014, for related information. The MCAI can be found in the AD docket on the Internet at: http://www.regulations.gov/#!documentDetail;D=FAA-2014-0876-0002.

(i) Material Incorporated by Reference

(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this

[[Page 4769]]

paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.
(2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise.
(i) Costruzioni Aeronautiche TECNAM Service Bulletin No. SB 170- CS-Ed 1, Rev 1, dated September 25, 2014.
(ii) Reserved.
(3) For Costruzioni Aeronautiche TECNAM service information identified in this AD, contact Costruzioni Aeronautiche Tecnam Airworthiness Office, Via Maiorise-81043 Capua (CE) Italy; telephone: +39 0823 997538; fax: +39 0823 622899; email: technical.support@tecnam.com; Internet: http://www.tecnam.com/Customer-Care/Service-Bulletins.aspx.
(4) You may review this referenced service information at the FAA, Small Airplane Directorate, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call (816) 329-4148. In addition, you can access this service information on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2014-0876.
(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to add an AD that would apply to Costruzioni Aeronautiche Tecnam srl Model P2006T airplanes. The NPRM was published in the Federal Register on October 29, 2014 (79 FR 64347). The NPRM proposed to correct an unsafe condition for the specified products and was based on mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country. The MCAI states:

During a pre-flight inspection of a P2006T aeroplane, which included the opening of engine nacelle, a crack was found on the engine exhaust pipe Part Number (P/N) 26-7-1800-1.
This condition, if not detected and corrected, could lead to engine damage, possibly resulting in damage to the aeroplane and injury to the occupants.
To address this potential unsafe condition, Costruzioni Aeronautiche TECNAM issued Service Bulletin (SB) SB 170-CS-Ed 1 Rev1.
For the reasondescribed above, this AD requires a one-time inspection of the affected engine exhaust pipes and, depending on findings, replacement.

The MCAI can be found in the AD docket on the Internet at: http://www.regulations.gov/#!documentDetail;D=FAA-2014-0876-0002.

Comments

We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM or on the determination of the cost to the public.

Conclusion

We reviewed the relevant data and determined that air safety and the public interest require adopting the AD as proposed except for minor editorial changes. We have determined that these minor changes:
Are consistent with the intent that was proposed in the NPRM (79 FR 64347, October 29, 2014) for correcting the unsafe condition; and
Do not add any additional burden upon the public than was already proposed in the NPRM.

Relative Service Information

We reviewed Costruzioni Aeronautiche TECNAM Service Bulletin No.SB 170-CS-Ed 1, Rev 1, dated September 25, 2014. The service bulletin describes procedures for inspecting and replacing (as necessary) the engine exhaust pipes. You can find this service information on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2014-0876.

Costs of Compliance

We estimate that this AD will affect 10 products of U.S. registry. We also estimate that it would take about .5 work-hour per product to comply with the basic requirements of this AD. The average labor rate is $85 per work-hour.
Based on these figures, we estimate the cost of this AD on U.S. operators to be $425, or $42.50 per product.
In addition, we estimate that any necessary follow-on actions would take about .5 work-hour and require parts costing $343, for a cost of $385.50 per product. We have no way of determining the number of products that may need these actions.

Paperwork Reduction Act

A federal agency may not conduct or sponsor, and a person is not required to respond to, nor shall a person be subject to penalty for failure to comply with a collection of information subject to the requirements of the Paperwork Reduction Act unless that collection of information displays a current valid OMB control number. The control number for the collection of information required by this AD is 2120- 0056. The paperwork cost associated with this AD has been detailed in the Costs of Compliance section of this document and includes time for reviewing instructions, as well as completing and reviewing the collection of information. Therefore, all reporting associated with this AD is mandatory. Comments concerning the accuracy of this burden and suggestions for reducing the burden should be directed to the FAA at 800 Independence Ave. SW., Washington, DC 20591. ATTN: Information Collection Clearance Officer, AES-200.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue[[Page 4768]]

rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between thenational government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this AD:
(1) Is not a ``significant regulatory action'' under Executive Order 12866,
(2) Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),
(3) Will not affect intrastate aviation in Alaska, and
(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2014- 0876; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains the NPRM, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.