AD 2014-22-08

We are adopting a new airworthiness directive (AD) for all Airbus Model A318, A319, A320, and A321 series airplanes. This AD was prompted by a determination that more restrictive airworthiness limitations are necessary. This AD requires revising the maintenance or inspection program as applicable. We are issuing this AD to prevent a safety-significant latent failure (which is not annunciated) which, in combination with one or more other specific failures or events, would result in a hazardous or catastrophic failure condition.

Final rule.

Adoption of the Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0 1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD):

2014-22-08 Airbus: Amendment 39-18013. Docket No. FAA-2014-0452; Directorate Identifier 2013-NM-185-AD.

(a) Effective Date

This AD becomes effective December 17, 2014.

(b) Affected ADs

None.

(c) Applicability

This AD applies to Airbus Model A318-111, -112, -121, and -122 airplanes; Model A319-111, -112, -113, -114, -115, -131, -132, and - 133 airplanes; Model A320-111, -211, -212, -214, -231, -232, and - 233 airplanes; and Model A321-111, -112, -131, -211, -212, -213, - 231, and -232 airplanes; certificated in any category;all manufacturer serial numbers.

(d) Subject

Air Transport Association (ATA) of America Code 05, Time Limits and Maintenance Checks.

(e) Reason

This AD was prompted by a determination that more restrictive airworthiness limitations are necessary. We are issuing this AD to prevent a safety-significant latent failure (which is not annunciated) which, in combination with one or more other specific failures or events, would result in a hazardous or catastrophic failure condition.

(f) Compliance

Comply with this AD within the compliance times specified, unless already done.

(g) Maintenance or Inspection Program Revision

Within 30 days after the effective date of this AD, revise the maintenance or inspection program, as applicable, by incorporating Airbus A318/A319/A320/A321 Airworthiness Limitations Section (ALS) Part 3, Certification Maintenance Requirements (CMR), Revision 1, dated June 15, 2012. The initial compliance time for accomplishing the tasks specified in Airbus A318/A319/A320/A321 ALS Part 3, CMR, Revision 1, dated June 15, 2012, is at the applicable time specified in the Record of Revisions of Airbus A318/A319/A320/A321 ALS Part 3, CMR, Revision 1, dated June 15, 2012; or within 30 days after the effective date of this AD, whichever occurs later.

(h) No Alternative Actions or Intervals

After accomplishing the revisions required by paragraph (g) of this AD, no alternative actions (e.g., inspections) or intervals may be used unless the actions or intervals are approved as an alternative method of compliance in accordance with the procedures specified in paragraph (i) of this AD.

(i) Other FAA AD Provisions

The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your

[[Page 67044]]

request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Sanjay Ralhan, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, Washington 98057- 3356; telephone 425-227-1405; fax 425-227-1149. Information may be emailed to: 9-ANM-116-AMOC-REQUESTS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, International Branch, ANM-116, Transport AirplaneDirectorate, FAA; or the European Aviation Safety Agency (EASA); or Airbus's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature.

(j) Related Information

Refer to Mandatory Continuing Airworthiness Information (MCAI) European Aviation Safety Agency Airworthiness Directive 2013-0148, dated July 16, 2013, for related information. This MCAI may be found in the AD docket on the Internet at http://www.regulations.gov/#!documentDetail;D=FAA-2014-0452-0002.

(k) Material Incorporated by Reference

(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.
(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise.
(i) Airbus A318/A319/A320/A321 Airworthiness Limitations Section (ALS) Part 3, Certification Maintenance Requirements (CMR), Revision 1, dated June 15, 2012.
(ii) Reserved.
(3) For service information identified in this AD, contact Airbus, Airworthiness Office--EIAS, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France; telephone +33 5 61 93 36 96; fax +33 5 61 93 44 51; email account.airworth-eas@airbus.com; Internet http://www.airbus.com.
(4) You may view this service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.
(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to all Airbus Model A318, A319, A320, and A321 series airplanes. The NPRM published in the Federal Register on July 18, 2014 (79 FR 41938).
The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community, has issued EASA Airworthiness Directive 2013-0148, dated July 16, 2013 (referred to after this as the Mandatory Continuing Airworthiness Information, or ``the MCAI''), to correct an unsafe condition all Airbus Model A318, A319, A320, and A321 series airplanes. The MCAI states:

The airworthiness limitations for Airbus aeroplanes are currently published in Airworthiness Limitations Section (ALS) documents. The airworthiness limitations applicable to the Certification Maintenance Requirements (CMR) were previously specified in AIRBUS A318/A319/A320/A321 CMR document referenced AI/ ST4/993.436/88.
DGAC France issued AD F-2005-101 [(http://ad.easa.europa.eu/blob/easa_ad_2005_5886_F20051010tb_superseded.pdf/AD_F-2005-101_2)] (EASA approval 2005-5886) to require compliance with the maintenance tasks as specified in that document.
Since that [DGAC France] AD was issued, the CMR tasks are specified in Airbus A318/A319/A320/A321 ALS Part 3, which is approved by EASA. The original issue of this document introduced more restrictive maintenance requirements and/or airworthiness limitations. Failure to comply with the maintenance requirements contained in this document could result in an unsafe condition.
For the reasons described above, this [EASA] AD supersedes DGAC France AD F-2005-101 and requires the implementation of the instructions and airworthiness limitations as specified in Airbus A318/A319/A320/A321 ALS Part 3 Revision 01.

[[Page 67043]]

The unsafe condition is a safety-significant latent failure (which is not annunciated) which, in combination with one or more other specific failures or events, would result in a hazardous or catastrophic failure condition. You may examine the MCAI in the AD docket on the Internet at http://www.regulations.gov/#!documentDetail;D=FAA-2014-0452-0002.

Comments

We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM (79 FR 41938, July 18, 2014) or on the determination of the cost to the public.

Conclusion

We reviewed the relevant data and determined that air safety and the public interest require adopting this AD as proposed except for minor editorial changes. We have determined that these minor changes:
Are consistent with the intent that was proposed in the NPRM (79 FR 41938, July 18, 2014) for correcting the unsafe condition; and
Do not add any additional burden upon the public than was already proposed in the NPRM (79 FR 41938, July 18, 2014).

Costs of Compliance

We estimate that this AD affects 851 airplanes of U.S. registry.
We also estimate that it will take about 1 work-hour per product to comply with the basic requirements of this AD. The average labor rate is $85 per work-hour. Required parts will cost about $0 per product. Based on these figures, we estimate the cost of this AD on U.S. operators to be $72,335, or $85 per product.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
1. Is not a ``significant regulatory action'' under Executive Order 12866;
2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov/#!docketDetail;D=FAA-2014-0452; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone 800-647- 5527) is in the ADDRESSES section.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.