AD 2012-19-05

We are adopting a new airworthiness directive (AD) for certain Fokker Services B.V. Model F.28 Mark 0070 and 0100 airplanes. This AD was prompted by reports of burned contacts in a certain production break plug and its corresponding receptacle. This AD requires modifying galley power supply wiring by disconnecting it from the affected plug/ receptacle and reconnecting the power supply wiring through splices. We are issuing this AD to prevent a high electrical load, which might lead to overheating of the galley power supply wiring and/or the electrical connector and consequent smoke or fire in the galley area, which could result in damage to the airplane and injury to occupants.

Final rule.

Adoption of the Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0 1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

0 2. The FAA amends Sec. 39.13 by adding the following new AD:

2012-19-05 Fokker Services B.V.: Amendment 39-17200. Docket No. FAA- 2012-0593; Directorate Identifier 2011-NM-238-AD.

(a) Effective Date

This airworthiness directive (AD) becomes effective October 29, 2012.

(b) Affected ADs

None.

(c) Applicability

This AD applies to Fokker Services B.V. Model F.28 Mark 0070 and 0100 airplanes, certificated in any category; serial numbers (S/N) 11340 through 11343 inclusive, 11347, 11348, 11350 through 11356 inclusive, 11359, 11360, 11361, 11367 through 11371 inclusive, 11374 through 11378 inclusive, 11382 through 11385 inclusive, 11387 through 11390 inclusive, 11394 through 11397 inclusive, 11400 through 11423 inclusive, 11425 through 11432 inclusive, 11434 through 11439 inclusive, 11441 through 11453 inclusive, and 11456 through 11585 inclusive.

(d) Subject

Air Transport Association (ATA) of America Code 24, Electrical Power.

(e) Reason

This AD was prompted by reports of burned contacts in a certain production break plug and its corresponding receptacle. We are issuing this AD to prevent a high electrical load, which might lead to overheating of the galley power supply wiring and/or the electrical connector and consequent smoke or fire in the galley area, which could result in damage to the airplane and injury to occupants.

(f) Compliance

You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.

(g) Modification

Within 24 months after the effective date ofthis AD: Modify the galley power supply wiring, in accordance with the Accomplishment Instructions of Fokker Service Bulletin SBF100-24-044, dated July 14, 2011, including Fokker Manual Change Notification--Maintenance Documentation MCNM-F100-148, dated July 14, 2011.

(h) Other FAA AD Provisions

The following provisions also apply to this AD:

[[Page 58767]]

(1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone (425) 227-1137; fax (425) 227-1149. Information may be emailed to: 9-ANM-116-AMOC-REQUESTS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD.
(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.

(i) Related Information

Refer to MCAI European Aviation Safety Agency Airworthiness Directive 2011-0183, dated September 23, 2011; and Fokker Service Bulletin SBF100-24-044, dated July 14, 2011, including Fokker Manual Change Notification--Maintenance Documentation MCNM-F100-148, dated July 14, 2011; for related information.

(j) Material Incorporated by Reference

(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.
(2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise.
(i) Fokker Service Bulletin SBF100-24-044, dated July 14, 2011, including Fokker Manual Change Notification--Maintenance Documentation MCNM-F100-148, dated July 14, 2011.
(ii) Reserved.
(3) For service information identified in this AD, contact Fokker Services B.V., Technical Services Dept., P.O. Box 231, 2150 AE Nieuw-Vennep, the Netherlands; telephone +31 (0)252-627-350; fax +31 (0)252-627-211; email technicalservices.fokkerservices@stork.com; Internet http://www.myfokkerfleet.com.
(4) You may review copies of the service information at theFAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.
(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to the specified products. That NPRM was published in the Federal Register on June 12, 2012 (77 FR 34872). That NPRM proposed to correct an unsafe condition for the specified products. The MCAI states:

Reports have been received about burned contacts in production break plug P 4259B and corresponding receptacle J 4259A. After investigation, it was concluded that the high

[[Page 58766]]

electrical load on the contacts M, L and X, in combination with the electrical loads on the adjacent connections, may have resulted in these occurrences.
This condition, if not detected and corrected, can lead to overheating of the galley power supply wiring and/or the electrical connector and consequent smoke or fire in the galley area, possibly resulting in damage to the aeroplane and injury to occupants.
For the reasons described above, this [European Aviation Safety Agency] AD requires modification of the galley power supply wiring by disconnecting it from the affected plug/receptacle and reconnecting the power supply wiring through splices.

You may obtain further information by examining the MCAI in the AD docket.

Comments

We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM (77 FR 34872, June 12, 2012) or on the determination of the cost to the public.

Conclusion

We reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed--except for minor editorial changes. We have determined that these minor changes:
Are consistent with the intent that was proposed in the NPRM (77 FR 34872, June 12, 2012) for correcting the unsafe condition; and
Do not add any additional burden upon the public than was already proposed in the NPRM (77 FR 34872, June 12, 2012).

Costs ofCompliance

We estimate that this AD will affect 4 products of U.S. registry. We also estimate that it will take about 4 work-hours per product to comply with the basic requirements of this AD. The average labor rate is $85 per work-hour. Required parts will cost about $210 per product. Where the service information lists required parts costs that are covered under warranty, we have assumed that there will be no charge for these parts. As we do not control warranty coverage for affected parties, some parties may incur costs higher than estimated here. Based on these figures, we estimate the cost of this AD to the U.S. operators to be $2,200, or $550 per product.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
1. Is not a ``significant regulatoryaction'' under Executive Order 12866;
2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains the NPRM (77 FR 34872, June 12, 2012), the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.