AD 2012-16-15

We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc. Model CL-600-2B19 (Regional Jet Series 100 & 440) airplanes. This AD was prompted by reports of jamming/malfunctioning of the left-hand engine thrust control mechanism. This AD requires modifying the left-hand engine upper core-cowl. We are issuing this AD to prevent jamming/malfunctioning of the left-hand engine thrust control mechanism, which could lead to loss of control of the airplane.

Final rule.

Adoption of the Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0 1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

0 2. The FAA amends Sec. 39.13 by adding the following new AD:

2012-16-15 Bombardier, Inc.: Amendment 39-17162. Docket No. FAA- 2012-0328; Directorate Identifier 2011-NM-259-AD.

(a) Effective Date

This airworthiness directive (AD) becomes effective September 25, 2012.

(b) Affected ADs

None.

(c) Applicability

This AD applies to Bombardier, Inc. Model CL-600-2B19 (Regional Jet Series 100 & 440) airplanes, certificated in any category; serial numbers 7003 through 7067 inclusive, 7069 through 7990 inclusive, and 8000 through 8112 inclusive.

(d) Subject

Air Transport Association (ATA) of America Code 71: Powerplant.

(e) Reason

This AD was prompted by reports of jamming/malfunctioning of the left-hand engine thrust control mechanism. We are issuing this AD to prevent jamming/malfunctioning of the left-hand engine thrust control mechanism, which could lead to loss of control of the airplane.

(f) Compliance

You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.

(g) Actions

Within 36 months or 6,000 flight hours after the effective date of this AD, whichever occurs first: Modify the left-hand engine upper core-cowl, in accordance with the Accomplishment Instructions of Bombardier Service Bulletin 601R-71-033, dated August 24, 2011.

(h) Other FAA AD Provisions

The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, New York Aircraft Certification Office (ACO), ANE-170, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the New York ACO, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO, 1600 Stewart Avenue, Suite 410, Westbury, New York 11590; telephone 516-228-7300; fax 516-794-5531. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/ certificate holding district office. The AMOC approval letter must specifically reference this AD.
(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.

(i) Related Information

Refer to MCAI Canadian Airworthiness Directive CF-2011-38, dated October 19, 2011; and Bombardier Service Bulletin 601R-71-033, dated August 24, 2011; for related information.

(j) Material Incorporated by Reference

(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.
(2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise.
(i) Bombardier Service Bulletin 601R-71-033, dated August 24, 2011.
(ii) Reserved.
(3) For Bombardier service information identified in this AD, contact Bombardier, Inc., 400 C[ocirc]te-Vertu Road West, Dorval, Qu[eacute]bec H4S 1Y9, Canada; telephone 514-855-5000; fax 514-855- 7401; email thd.crj@aero.bombardier.com; Internet http://www.bombardier.com.
(4) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.
(5) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at an NARA facility, call 202-741-6030, or go to http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html.

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to the specified products. That NPRM was published in the Federal Register on April 6, 2012 (77 FR 20746). That NPRM proposed to correct an unsafe condition for the specified products. The MCAI states:

There have been several reported incidents of jamming/ malfunctioning of the left hand (L/H) engine thrust control mechanism on the affected aeroplanes. The investigation has shown that an improperly stowed or dislodged upper core-cowl-door Hold Open Rod, can impede a Fuel Control Unit (FCU) function by obstructing the movement of the FCU actuating lever arm, hence rendering the L/H engine thrust control inoperable.
Due to the engine's orientation, the subject FCU fouling is limited only to the L/H engine installation on the affected twin engine powered aeroplanes; however the potential hazard of any in- flight engine shut down caused by jammed engine fuel control lever is a safety concern that warrants mitigating action.
In order to help alleviate the possibility of an in-flight engine shut down due to the subject fouling of the FCU lever by the core-cowl-door Hold Open Rod, Bombardier has issued a Service Bulletin (SB) to install a new bracket at the L/H engine upper core- cowl-door location. This [Canadian] directive is issued to mandate the incorporation of the SB 601R-71-033 on the affected aeroplanes.

You may obtain further information by examining the MCAI in the AD docket.

Comments

We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM (77 FR 20746, April 6, 2012) or on the determination of the cost to the public.

Conclusion

We reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed--except for minor editorial changes. We have determined that these minor changes:
Are consistent with the intent that was proposed in the NPRM (77 FR 20746, April 6, 2012) for correcting the unsafe condition; and
Do not add any additional burden upon the public than was already proposed in the NPRM (77 FR 20746, April 6, 2012).

Costs of Compliance

We estimate that this AD will affect 601 products of U.S. registry. We also estimate that it will take about 2 work-hours per product to comply with the basic requirements of this AD. The average labor rate is $85 per work-hour. Required parts will cost about $54 per product. Where the service information lists required parts costs that are covered under warranty, we have assumed that there will be no charge for these parts. As we do not control warranty coverage for affected parties, some parties may incur costs higher than estimated here. Based on these figures, we estimate the cost of this AD to the U.S. operators to be $134,624, or $224 per product.

Authority for This RulemakingTitle 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial directeffect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:

[[Page 50372]]

1. Is not a ``significant regulatory action'' under Executive Order 12866;
2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains the NPRM (77 FR 20746, April 6, 2012), the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.