Discussion \n\n\tWe received a report of automatic retraction of the leading edge flaps during takeoff on a Boeing Model 747-400 airplane powered by Rolls-Royce RB211-524G/H engines. The automatic retraction was due to indications transmitted to the flap control unit (FCU) from the thrust reverser control system. In order to prevent impingement of efflux air from the thrust reversers during landing rollout, the FCU is designed to automatically retract the Group A leading edge flaps when a REV Amber signal is received from either both inboard or both outboard thrust reversers, and the airplane is on the ground. In this event, the first REV amber signal was received prior to V1 (takeoff decision speed). The second REV amber signal was received several seconds later, after takeoff decision speed. At that time, the FCU performed as designed and retracted the Group A leading edge flaps. At rotation the flight crew reported buffeting and stick shaker activation.After liftoff, a signal from the air/ground logic system caused the FCU to send a command to the Group A leading edge flaps to re-deploy after a five-second time delay. Re-deployment of the flaps takes approximately ten to fifteen additional seconds; during re-deployment, the flightcrew again reported buffeting and momentary stick shaker activation. The airplane jettisoned fuel and was landed safely; all four of the thrust reversers deployed and stowed normally after landing. \n\tIn addition, one operator reported 12 single-engine REV indications during takeoff over the past three years, leading to seven rejected takeoffs. The incident described above was the first known simultaneous two- engine event. \n\tThese conditions, if not corrected, could result in reduced climb performance during takeoff and consequent collision with terrain and obstacles or forced landing of the airplane. \n\nRelevant Service Information \n\n\tWe reviewed Boeing Alert Service Bulletin 747-78A2181, dated June 8, 2009. The service information describes procedures for modifying certain thrust reverser control system wiring to the FCU in the P414 and P415 panels. The modification includes re-routing and re- terminating one wire for each engine, and replacing the wire if necessary. \n\nFAA's Determination and Requirements of This AD \n\n\tNo airplanes affected by this AD are on the U.S. Register. We are issuing this AD because we evaluated all the relevant information and determined the unsafe condition described previously is likely to exist or develop on other products of the same type design. This AD requires accomplishing the actions specified in the service information described previously, except as described under "Difference Between the AD and the Service Information.'' \n\nDifference Between the AD and the Service Information \n\n\tOperators should note that Boeing Alert Service Bulletin 747- 78A2181, dated June 8, 2009, recommends that the modification be completed within 90 days (afterthe issue date of the service bulletin). This AD specifies a compliance time of 60 days. In developing this compliance time, we considered the manufacturer's recommended 90-day compliance time (after June 8, 2009, which is the service bulletin issue date), a risk assessment of the unsafe condition, the scope of work required, and the number of affected airplanes, as well as the time normally required for the rulemaking process to be completed (approximately 30 days). In consideration of both of these factors, we find that a compliance time of 60 days after the effective date of this AD will fall approximately at the same time (calendar date) as the compliance time recommended by the manufacturer, and represents an appropriate interval of time for affected airplanes to continue to operate without compromising safety. By adjusting the compliance time interval in this way: \n\t1. Operators will get a full 60 days in which to complete the modification; and \n\t2. The modification can be donewithin an interval of time that parallels normal scheduled maintenance for most affected operators. \n\tThis difference has been coordinated with Boeing. \n\nFAA's Justification and Determination of the Effective Date \n\n\tAutomatic retraction of the leading edge flaps could result in reduced climb performance during takeoff. Such a restriction could result in failure to achieve a minimum rate of climb, and consequent collision with terrain or obstacles or forced landing of the airplane. Because of our requirement to promote safe flight of civil aircraft and thus, the critical need to assure the proper functioning of the FCU and the short compliance time involved with this action, this AD must be issued immediately. \n\tBecause an unsafe condition exists that requires the immediate adoption of this AD, and because no airplanes affected by this AD are on the U.S. Register, we find that notice and opportunity for prior public comment hereon are both impracticable and unnecessary and thatgood cause exists for making this amendment effective in less than 30 days. \n\nComments Invited \n\n\tThis AD is a final rule that involves requirements affecting flight safety, and we did not provide you with notice and an opportunity to provide your comments before it becomes effective. However, we invite you to send any written data, views, or arguments about this AD. Send your comments to an address listed under the ADDRESSES section. Include "Docket No. FAA-2009-0556; Directorate Identifier 2009-NM-112-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this AD. We will consider all comments received by the closing date and may amend this AD because of those comments. \n\tWe will post all comments we receive, without change, to http:// www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive aboutthis AD. \n\nAuthority for This Rulemaking \n\n\tTitle 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. "Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority. \n\tWe are issuing this rulemaking under the authority described in "Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action. \n\nRegulatory Findings \n\n\tThis AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. \n\tFor the reasons discussed above, I certify that this AD: \n\t(1) Is not a "significant regulatory action'' under Executive Order 12866, \n\t(2) Is not a "significant rule'' under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979), and \n\t(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. \n\tYou can find our regulatory evaluation and the estimated costs of compliance in the AD Docket. \n\nList of Subjects in 14 CFR Part 39 \n\n\tAir transportation, Aircraft, Aviation safety, Incorporation by reference, Safety. \n\nAdoption of the Amendment \n\nAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n1. The authority citation for part 39 continues to read as follows: \n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\nSec. 39.13 (Amended) \n\n2. The FAA amends Sec. 39.13 by adding the following new AD: