On November 3, 2006, the FAA issued AD 2006- 23-11, Amendment 39-14823 (71 FR 66229, November 14, 2006). That AD requires initial and repetitive on-wing or in-shop inspections of the HP/IP turbine bearing oil feed tube heat shield. That AD was the result of a report that a damaged outer heat shield caused fretting of the oil feed tubes. That condition, if not corrected, could result in an uncontained failure of the HP turbine disc and damage to the airplane.
Actions Since AD 2006-23-11 Was Issued
Since that AD was issued, the European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community, recently notified us that RR introduced a revised HP/IP turbine bearing support structure to terminate the repetitive inspections. This AD requires initial and repetitive on-wing or in-shop inspections of the HP/IP turbine bearing oil feed tube heat shield, and requires revising the HP/IP turbine bearing supportstructure as terminating action to the repetitive inspections in this AD. We are issuing this AD to prevent an uncontained failure of the HP turbine disc and damage to the airplane.
Relevant Service Information
We have reviewed and approved the technical contents of RR Service Bulletin (SB) No. RB.211-72-F117, Revision 2, dated September 25, 2006, RR SB No. RB.211-72-F227, Revision 1, dated October 8, 2007, and RR Immediate Operational Request SB No. RB.211-72-F048, Revision 11, dated September 9, 2006, that describe procedures for revising the HP/IP turbine bearing support structure. EASA classified these SBs as mandatory and issued AD 2007-0260 in order to ensure the airworthiness of these RR engines in Europe.
Bilateral Airworthiness Agreement
These engine models are manufactured in the United Kingdom and are type certificated for operation in the United States under the provisions of section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and the applicable bilateral airworthiness agreement. Under this bilateral airworthiness agreement, EASA has kept the FAA informed of the situation described above. We have examined the findings of EASA, reviewed all available information, and determined that AD action is necessary for products of this type design that are certificated for operation in the United States.
FAA's Determination and Requirements of This AD
Although no airplanes that are registered in the United States use these Trent 768-60, 772-60, and 772B-60 turbofan engines, the possibility exists that these engines could be used on airplanes that are registered in the United States in the future. The unsafe condition described previously is likely to exist or develop on other Trent 768- 60, 772-60, and 772B-60 turbofan engines of the same type design. We are issuing this AD to prevent an uncontained failure of the HP turbine disc and damage to the airplane. This AD requires initial and repetitive on-wing or in-shop inspections of the HP/IP turbine bearing oil feed tube heat shield, and requires revising the HP/IP turbine bearing support structure as terminating action to the repetitive inspections in this AD. You must use the service information described previously to perform the actions required by this AD.
FAA's Determination of the Effective Date
Since there are currently no domestic operators of this engine model, notice and opportunity for public comment before issuing this AD are unnecessary. Therefore, a situation exists that allows the immediate adoption of this regulation.
Comments Invited
This AD is a final rule that involves requirements affecting flight safety and was not preceded by notice and an opportunity for public comment. However, we invite you to send us any written relevant data, views, or arguments regarding this AD. Send your comments to an address listed under ADDRESSES. Include "AD Docket No. FAA-2006-26052; Directorate Identifier 2006-NE-30-AD'' in the subjectline of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of the rule that might suggest a need to modify it.
We will post all comments we receive, without change, to http://www.regulations.gov , including any personal information you provide. We will also post a report summarizing each substantive verbal contact with FAA personnel concerning this AD. Using the search function of the FDMS Web site, anyone can find and read the comments in any of our dockets, including the name of the individual who sent the comment (or signed the comment on behalf of an association, business, labor union, etc.). You may review the DOT's complete Privacy Act Statement in the Federal Register published on April 11, 2000 (65 FR 19477-78).
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov ; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday throughFriday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is the same as the Mail address provided in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, "General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator findsnecessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We have determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the National Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
1. Is not a "significant regulatory action'' under Executive Order 12866;
2. Is not a "significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and
3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory FlexibilityAct.
We prepared a summary of the costs to comply with this AD and placed it in the AD Docket. You may get a copy of this summary at the address listed under ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Adoption of the Amendment
Under the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. The FAA amends Sec. 39.13 by removing Amendment 39-14823 (71 FR 66229, November 14, 2006), and by adding a new airworthiness directive, Amendment 39-15275, to read as follows: