On September 14, 2007, the FAA issued Emergency AD 2007-19-53 for the specified model helicopters, which requires replacing each affected part-numbered and serial-numbered blade with an airworthy blade with a serial number not listed in the applicability of this AD. That action was prompted by three incidents in which blade tip weights were slung from the blades during flight causing significant vibration. The failures have occurred on blades being returned to service from Rotor Blades, Inc. (RBI), from as short as 12 minutes since repair to as long as 400 hours time-in-service. An investigation indicates that the tip weights were missing the adhesive that should have been applied during the weight-and-balance process on these blades. This condition, if not corrected, could result in loss of a blade tip weight, loss of a blade, and subsequent loss of control of the helicopter.
BHTI has issued the following Alert Service Bulletins (ASB):
No. 204-07-61for BHTI Model 204 helicopters,
No. 205-07-95 for BHTI Model 205 helicopters,
No. 205B-07-46 for BHTI Model 205B helicopters,
No. 212-07-125 for BHTI Model 212 helicopters, and
No. 412-07-123 for BHTI Model 412 helicopters.
All the ASBs are dated September 11, 2007, and contain a letter from RBI indicating certain blades processed by RBI may be missing the adhesive applied to the tip weight screws during the weight and balance process. Emergency AD 2007-19-53 had the Model 230 helicopters incorrectly linked to ASB No. 412-07-123; that ASB is for Model 412 helicopters. We have made that correction in this AD and determined that this change will neither increase the economic burden on any operator nor increase the scope of the AD.
Since the unsafe condition described is likely to exist or develop on other specified BHTI model helicopters of these same type designs, the FAA issued Emergency AD 2007-19-53 to prevent loss of a blade tip weight, loss of a blade, and subsequent loss of control of the helicopter. The AD requires replacing each affected blade with an airworthy blade. The short compliance time involved is required because the previously described critical unsafe condition can adversely affect the controllability or structural integrity of the helicopter. Therefore, replacing each affected blade with an airworthy blade is required before further flight, and this AD must be issued immediately.
Since it was found that immediate corrective action was required, notice and opportunity for prior public comment thereon were impracticable and contrary to the public interest, and good cause existed to make the AD effective immediately by individual letters issued on September 14, 2007, to all known U.S. owners and operators of the specified BHTI model helicopters. These conditions still exist, and the AD is hereby published in the Federal Register as an amendment to 14 CFR 39.13 to make it effective to all persons.
The FAA estimates thatthis AD will affect 1013 helicopters of U.S. registry, and it will take about 2 hours to determine if a blade is affected per helicopter at an average labor rate of $80 per work hour. The ASB contains a warranty statement that owners or operators of Bell helicopters who comply with the instructions in the ASB will be eligible to return defective blades identified by serial number in the compliance section to their nearest RBI facility for inspection and repair at no cost. Based on these figures, we estimate the total cost impact of the AD on U.S. operators to be $162,080, assuming all shipping inspection and repair costs are paid by RBI or Bell.
Comments Invited
This AD is a final rule that involves requirements that affect flight safety and was not preceded by notice and an opportunity for public comment; however, we invite you to submit any written data, views, or arguments regarding this AD. Send your comments to an address listed under ADDRESSES. Include "Docket No. FAA-2007-0180; Directorate Identifier 2007-SW-37-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of the AD. We will consider all comments received by the closing date and may amend the AD in light of those comments.
We will post all comments we receive, without change, to http://www.regulations.gov , including any personal information you provide. We will also post a report summarizing each substantive verbal contact with FAA personnel concerning this AD. Using the search function of the docket web site, you can find and read the comments to any of our dockets, including the name of the individual who sent the comment. You may review the DOT's complete Privacy Act Statement in the Federal Register published on April 11, 2000 (65 FR 19477-78).
Regulatory Findings
We have determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that the regulation:
1. Is not a "significant regulatory action'' under Executive Order 12866;
2. Is not a "significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and
3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared an economic evaluation of the estimated costs to comply with this AD. See the AD docket to examine the economic evaluation.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, "General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding a new airworthiness directive to read as follows: