AD 2007-21-04

The FAA is adopting a new airworthiness directive (AD) for all Boeing Model 727 airplanes. This AD requires doing an initial detailed inspection for cracks in the aft pressure bulkhead web; repairing any discrepancy; and doing repetitive detailed inspections, and doing related investigative actions, if necessary. This AD results from reports of cracking in the aft pressure bulkhead web. We are issuing this AD to detect and correct a cracked pressure bulkhead web, which could result in rapid decompression of the airplane.

Final rule.

2007-21-04 Boeing: Amendment 39-15222. Docket No. FAA-2007-28378; Directorate Identifier 2007-NM-089-AD. \n\nEffective Date \n\n\t(a) This AD becomes effective November 16, 2007. \n\nAffected ADs \n\n\t(b) None. \n\nApplicability \n\n\t(c) This AD applies to all Boeing Model 727, 727C, 727-100, 727- 100C, 727-200, and 727-200F series airplanes, certificated in any category. \n\nUnsafe Condition \n\n\t(d) This AD results from reports of cracking in the aft pressure bulkhead web. We are issuing this AD to detect and correct a cracked pressure bulkhead web, which could result in rapid decompression of the airplane. \n\nCompliance \n\n\t(e) You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done. \n\nInspection(s) and Corrective Actions \n\n\t(f) Do an initial detailed inspection for cracks in the aft pressure bulkhead web in accordance with the Accomplishment Instructions of Boeing Special Attention Service Bulletin 727-53- 0230, dated January 8, 2007; except as provided by note (a) in Table 1 of paragraph 1.E., "Compliance,'' of the service bulletin. Do the inspection at the compliance time identified in paragraph 1.E., "Compliance,'' of the service bulletin; except as provided by paragraph (g) of this AD. \n\n\t(1) If no crack is found, repeat the detailed inspection at the repeat interval identified in paragraph 1.E., "Compliance,'' of the service bulletin, except as provided by note (a) in Table 1 of paragraph 1.E., "Compliance,'' of the service bulletin. \n\n\t(2) If any crack is found, before further flight, repair the crack and do the related investigative actions, in accordance with the Accomplishment Instructions of the service bulletin. If any crack, disbonding, or corrosion is found during related investigative actions, before further flight, repair the discrepancy using a method approved in accordance with the procedures specified in paragraph (h) of this AD.(g) Where Boeing Special Attention Service Bulletin 727-53-0230, dated January 8, 2007, specifies a compliance time after the date of the service bulletin, this AD requires compliance within the specified compliance time after the effective date of this AD. \n\nAlternative Methods of Compliance (AMOCs) \n\n\t(h)(1) The Manager, Seattle Aircraft Certification Office (ACO), FAA, has the authority to approve AMOCs for this AD, if requested in accordance with the procedures found in 14 CFR 39.19. \n\n\t(2) To request a different method of compliance or a different compliance time for this AD, follow the procedures in 14 CFR 39.19. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO. \n\n\t(3) An AMOC that provides an acceptable level of safety may be used for any repair required by this AD, if it is approved by an Authorized Representativefor the Boeing Commercial Airplanes Delegation Option Authorization Organization who has been authorized by the Manager, Seattle ACO, to make those findings. For a repair method to be approved, the repair must meet the certification basis of the airplane, and the approval must specifically refer to this AD. \n\nMaterial Incorporated by Reference \n\n\t(i) You must use Boeing Special Attention Service Bulletin 727- 53-0230, dated January 8, 2007, to perform the actions that are required by this AD, unless the AD specifies otherwise. The Director of the Federal Register approved the incorporation by reference of this document in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Contact Boeing Commercial Airplanes, P.O. Box 3707, Seattle, Washington 98124-2207, for a copy of this service information. You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information onthe availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html .

Examining the Docket \n\n\tYou may examine the AD docket on the Internet at http://dms.dot.gov or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The Docket Operations office (telephone (800) 647-5527) is located on the ground floor of the West Building at the DOT street address stated in the ADDRESSES section. \n\nDiscussion \n\n\tThe FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to all Boeing Model 727 airplanes. That NPRM was published in the Federal Register on June 25, 2007 (72 FR 34646). That NPRM proposed to require doing an initial detailed inspection for cracks in the aft pressure bulkhead web; repairing any discrepancy; and doing repetitive detailed inspections, and doing related investigative actions, if necessary. \n\nComments \n\n\tWe provided the public the opportunity to participate in the development of this AD. We have considered the comment received. The commenter, Boeing, supports the NPRM. \n\nConclusion \n\n\tWe have carefully reviewed the available data, including the comment received, and determined that air safety and the public interest require adopting the AD as proposed. \n\nCosts of Compliance \n\n\tThere are about 842 airplanes of the affected design in the worldwide fleet. This AD affects about 459 airplanes of U.S. registry. The detailed inspection takes about 1 work hour per airplane, at an average labor rate of $80 per work hour. Based on these figures, the estimated cost of this AD for U.S. operators is $36,720, or $80 per airplane. \n\nAuthority for This Rulemaking \n\n\tTitle 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority. \n\tWe are issuing this rulemaking under theauthority described in Subtitle VII, Part A, Subpart III, Section 44701, "General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action. \n\nRegulatory Findings \n\n\tWe have determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. \n\n\tFor the reasons discussed above, I certify that this AD: \n\n\t(1) Is not a "significant regulatory action'' under Executive Order 12866; \n\t(2) Is not a "significant rule'' under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and \n\t(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. \n\n\tWe prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket. See the ADDRESSES section for a location to examine the regulatory evaluation. \n\nList of Subjects in 14 CFR Part 39 \n\n\tAir transportation, Aircraft, Aviation safety, Incorporation by reference, Safety. \n\nAdoption of the Amendment \n\nAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n1. The authority citation for part 39 continues to read as follows: \n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\nSec. 39.13 (Amended) \n\n2. The Federal Aviation Administration (FAA) amends Sec. 39.13 by adding the following new airworthiness directive (AD):