On November 1, 2004, we issued AD 2004-23- 03, Amendment 39-13858 (69 FR 64653, November 8, 2004). That AD requires initial and repetitive borescope inspections of the HP-IP turbine internal and external oil vent tubes for coking and carbon buildup, and cleaning or replacing the vent tubes if necessary. That AD was the result of a report of an RB211 Trent 700 series engine experiencing a disk shaft separation, overspeed of the IP turbine rotor, and multiple blade release of IP turbine blades. The findings suggested these events resulted from an internal oil fire in the HP-IP turbine oil vent tubes due to coking and carbon buildup. This fire led to a second fire in the internal air cavity below the IP turbine disk drive shaft. That condition, if not corrected, could result in uncontained engine failure and damage to the airplane.
Actions Since AD 2004-23-03 Was Issued
Since AD 2004-23-03 was issued, the European Aviation Safety Agency (EASA), which isthe airworthiness authority for the European Union, notified us that an unsafe condition may exist on RB211 Trent 700 series turbofan engines. EASA advises that recently an oil vent tube ruptured as a result of blockage, leading to significant loss of engine oil, on an RB211 Trent 700 series turbofan engine. This incident indicates that further measures are necessary to control carbon buildup in the oil vent tubes.
Relevant Service Information
We have reviewed and approved the technical contents of RR Alert Service Bulletin (ASB) No. RB.211-72-AE302, Revision 3, dated September 20, 2006. That ASB describes procedures for borescope inspections, cleaning, and replacement if necessary of the internal and external oil vent tubes. For internal oil vent tubes to pass inspection, they must allow cleaning tool, number HU80298 to pass through them. AD 2004-23-03 was less stringent in that it allowed tubes that an 8 mm or 6 mm diameter borescope could pass through, back into service. EASA classified this ASB as mandatory and issued AD 2006-0355, dated December 4, 2006, in order to ensure the airworthiness of these RB211 Trent 700 series turbofan engines in Europe.
Bilateral Airworthiness Agreement
These engine models are manufactured in the United Kingdom and are type certificated for operation in the United States under the provisions of section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and the applicable bilateral airworthiness agreement. Under this bilateral airworthiness agreement, EASA kept the FAA informed of the situation described above. We have examined the findings of EASA, reviewed all available information, and determined that AD action is necessary for products of this type design that are certificated for operation in the United States.
FAA's Determination and Requirements of This AD
Although no airplanes that are registered in the United States use these RB211 Trent 700 series turbofan engines, the possibility exists that the engines could be used on airplanes that are registered in the United States in the future. The unsafe condition described previously is likely to exist or develop on other RB211 Trent 700 series turbofan engines of the same type design. This AD requires initial and repetitive borescope inspections of the HP-IP turbine internal and external oil vent tubes for coking and carbon buildup, and cleaning or replacing the vent tubes if necessary. We are issuing this AD to prevent internal oil fires due to coking and carbon buildup, that could cause uncontained engine failure and damage to the airplane. You must use the service information described previously to perform the actions required by this AD.
FAA's Determination of the Effective Date
Since there are currently no domestic operators of this engine model, notice and opportunity for public comment before issuing this AD are unnecessary. Therefore, a situation exists that allows the immediate adoption of this regulation.Comments Invited
This AD is a final rule that involves requirements affecting flight safety and was not preceded by notice and an opportunity for public comment; however, we invite you to send us any written relevant data, views, or arguments regarding this AD. Send your comments to an address listed under ADDRESSES. Include "AD Docket No. FAA-2005-19559; Directorate Identifier 2004-NE-03-AD'' in the subject line of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of the rule that might suggest a need to modify it.
We will post all comments we receive, without change, to http://dms.dot.gov , including any personal information you provide. We will
also post a report summarizing each substantive verbal contact with FAA personnel concerning this AD. Using the search function of the DMS Web site, anyone can find and read the comments in any of our dockets, including the name of the individual who sent thecomment (or signed the comment on behalf of an association, business, labor union, etc.). You may review the DOT's complete Privacy Act Statement in the
Federal Register published on April 11, 2000 (65 FR 19477-78) or you may visit http://dms.dot.gov.
Examining the AD Docket
You may examine the docket that contains the AD, any comments received, and any final disposition in person at the Docket Management Facility Docket Office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The Docket Office (telephone (800) 647-5227) is located on the plaza level of the Department of Transportation Nassif Building at the street address stated in ADDRESSES. Comments will be available in the AD docket shortly after the DMS receives them.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, "General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We have determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
Forthe reasons discussed above, I certify that the regulation:
1. Is not a "significant regulatory action'' under Executive Order 12866;
2. Is not a "significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and
3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a summary of the costs to comply with this AD and placed it in the AD Docket. You may get a copy of this summary by sending a request to us at the address listed under ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Adoption of the Amendment
Under the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. The FAA amends Sec. 39.13 by removing Amendment 39-13858 (69 FR 64653, November 8, 2004), and by adding a new airworthiness directive, Amendment 39-14892, to read as follows: