Examining the Docket \n\n\tYou may examine the airworthiness directive (AD) docket on the Internet at http://dms.dot.gov or in person at the Docket Management Facility office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The Docket Management Facility office (telephone (800) 647-5227) is located on the plaza level of the Nassif Building at the street address stated in the ADDRESSES section. \n\nDiscussion \n\n\tThe FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to certain Boeing Model 737-600, -700, -700C, -800, and -900 series airplanes. That NPRM was published in the Federal Register on July 5, 2005 (70 FR 38636). That NPRM proposed to require modification of certain wire bundles located above the center fuel tank. \n\nComments \n\n\tWe provided the public the opportunity to participate in the development of this AD. We have considered the comments received. \n\nRequest for Clarification of Correct Type of Material for Lacing Tape \n\n\tOne commenter states that the service bulletin referenced in the NPRM identifies an incorrect type of material for the lacing tape used to tie the subject wire bundles. The commenter reiterates the information in the service bulletin and notes that the material identified therein does not exist. The commenter asks for clarification of the correct type of material for the lacing tape. \n\n\tWe agree with the commenter that clarification is necessary. This AD now identifies the correct type of material for the lacing tape for which an incorrect material was specified in the service bulletin. Lacing tape part number (P/N) BMS 13-54, having Type I, Class 2, Finish C, Grade D, shown in sheet 3 of Figures 5 and 6 of the Accomplishment Instructions of the service bulletin, does not exist; the correct material is BMS 13-54, having Type II, Class 1, Finish D/C, Grade D, white or Type III, Class 1, Finish C, Grade D, white, anysize. The manufacturer is aware of this discrepancy, agrees with the change, and has issued Boeing Information Notice (IN) 737-28-1209 IN 01, dated July 28, 2005, to inform operators of the error. We have included this information in paragraph (f) of this AD. \n\nRequest To Increase Work Hours \n\n\tOne commenter asks that the work hours specified to accomplish the modification be increased. The commenter states that the referenced service bulletin shows the work hours necessary as 40, but the NPRM specifies only 4 work hours. \n\n\tWe do not agree. The estimate of 40 work hours specified in the service bulletin includes time for gaining access and closing up. The cost analysis in AD rulemaking actions, however, typically does not include costs such as the time required to gain access and close up, time necessary for planning, or time necessitated by other administrative actions. Those incidental costs may vary significantly among operators and are almost impossible to calculate. We recognize that, in doing the actions required by an AD, operators may incur incidental costs in addition to the direct costs. However, the estimate of 4 work hours, as proposed and as specified in this AD, represents the time necessary to perform only the actions actually required by this AD. We have not changed the AD in this regard. \n\nClarification of Alternative Method of Compliance (AMOC) Paragraph \n\n\tWe have changed this AD to clarify the appropriate procedure for notifying the principal inspector before using any approved AMOC on any airplane to which the AMOC applies. \n\nConclusion \n\n\tWe have carefully reviewed the available data, including the comments received, and determined that air safety and the public interest require adopting the AD with the changes described previously. We have determined that these changes will neither increase the economic burden on any operator nor increase the scope of the AD. \n\nCosts of Compliance \n\n\tThere are about 1,636 airplanes of the affected design in the worldwide fleet. This AD affects about 650 airplanes of U.S. registry. The modification takes about 4 work hours per airplane, at an average labor rate of $65 per work hour. Required parts cost about $1,446 per airplane. Based on these figures, the estimated cost of the AD for U.S. operators is $1,108,900, or $1,706 per airplane. \n\nAuthority for This Rulemaking \n\n\tTitle 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority. \n\n\tWe are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, "General requirements." Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action. \n\nRegulatory Findings \n\n\tWe have determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. \n\n\tFor the reasons discussed above, I certify that this AD: \n\n\t(1) Is not a "significant regulatory action" under Executive Order 12866; \n\n\t(2) Is not a "significant rule" under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and \n\n\t(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. \n\n\tWe prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket. See the ADDRESSES section for a location to examine the regulatory evaluation. \n\nList of Subjects in 14 CFR Part 39 \n\n\tAir transportation, Aircraft, Aviation safety, Incorporation by reference, Safety. \n\nAdoption of the Amendment \n\nAccordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows: \n\nPART 39--AIRWORTHINESS DIRECTIVES \n\n1. The authority citation for part 39 continues to read as follows: \n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\nSec. 39.13 (Amended) \n\n2. The Federal Aviation Administration (FAA) amends Sec. 39.13 by adding the following new airworthiness directive (AD):