AD 2004-03-22

This amendment adopts a new airworthiness directive (AD), applicable to certain Dassault Model Falcon 2000 series airplanes, that requires modification of the forward ribs of the left and right engine pylons to plug holes left open during production. This action is necessary to prevent fuel leakage into a "hot" section of the engine, and consequent propagation of an uncontained engine fire. This action is intended to address the identified unsafe condition.

Final rule.

2004-03-22 Dassault Aviation: Amendment 39-13466. Docket 2002-NM- 233-AD.

Applicability: Model Falcon 2000 series airplanes on which Dassault Modification M2111 has not been installed, certificated in any category.

Compliance: Required as indicated, unless accomplished previously.

To prevent fuel leakage into a "hot" section of the engine, and consequent propagation of an uncontained engine fire, accomplish the following:

Modification of the Engine Pylons

(a) Within 7 months after the effective date of this AD, modify the forward ribs of the left and right engine pylons by plugging the two 4-millimeter holes in each rib in accordance with the Accomplishment Instructions of Dassault Service Bulletin F2000-248, dated August 12, 2002. Although the service bulletin specifies to submit certain information to the manufacturer, this AD does not include such a requirement.

Alternative Methods of Compliance

(b) In accordance with 14 CFR 39.19, the Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate, is authorized to approve alternative methods of compliance for this AD.

Incorporation by Reference

(c) The actions shall be done in accordance with Dassault Service Bulletin F2000-248, dated August 12, 2002. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Dassault Falcon Jet, P.O. Box 2000, South Hackensack, New Jersey 07606. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

Note 1: The subject of this AD is addressed in French airworthiness directive 2002-413(B), dated August 7, 2002.

Effective Date

(d) This amendment becomes effective on March 17, 2004.

A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain Dassault Model Falcon 2000 series airplanes was published in the Federal Register on December 4, 2003 (68 FR 67816). That action proposed to require modification of the forward ribs of the left and right engine pylons to plug holes left open during production.

Comments

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.

Conclusion

We have determined that air safety and the public interest require the adoption of the rule as proposed.

Cost Impact

We estimate that 119 airplanes of U.S. registry will be affected by this AD, that it will take approximately 1 work hour per airplane to accomplish the required actions, and that the average labor rate is $65 per work hour. The cost of required parts is minimal. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $7,735, or $65 per airplane.

The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.

Regulatory Impact

The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this action (1) is not a "significant regulatory action" under Executive Order 12866; (2) is not a "significant rule" under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

39.13 [Amended]

2. Section 39.13 is amended by adding the following new airworthiness directive: