The FAA has received reports from the manufacturer of Boeing Model 747-400 series airplanes, indicating that there have been two cases of shafts in the rudder feel, centering, and trim mechanisms with either elongated holes or extra holes and drill starts. The shafts were found installed on airplanes in the factory. The cause of the discrepancies in the shafts is due to manufacturing and quality deficiencies at the supplier. This condition, if not corrected, could result in degradation/loss of rudder feel and centering, which could result in increased pilot workload and could lead to loss of control of the airplane. \n\nExplanation of Relevant Service Information \n\n\tThe FAA has reviewed and approved Boeing Service Bulletin 747-27-2392, dated February 20, 2003, which describes procedures for replacing the rudder feel, centering, and trim mechanism with a new or serviceable rudder feel, centering, and trim mechanism. Accomplishment of the actions specified inthe service bulletin is intended to adequately address the identified unsafe condition. \n\nExplanation of Requirements of the Rule \n\n\tSince an unsafe condition has been identified that is likely to exist or develop on other airplanes of the same type design that may be registered in the United States at some time in the future, this AD is being issued to prevent degradation/loss of rudder feel and centering, which could result in increased pilot workload and could lead to loss of control of the airplane. This AD requires replacing the rudder feel, centering, and trim mechanism with a new or serviceable rudder feel, centering, and trim mechanism. The actions are required to be accomplished in accordance with the service bulletin described previously. \n\nCost Impact \n\n\tNone of the Model 747-400 and -400F series airplanes affected by this action are on the U.S. Register. All airplanes included in the applicability of this rule currently are operated by non-U.S. operators under foreign registry; therefore, they are not directly affected by this AD action. However, the FAA considers that this rule is necessary to ensure that the unsafe condition is addressed in the event that any of these subject airplanes are imported and placed on the U.S. Register in the future. \n\n\tShould an affected airplane be imported and placed on the U.S. Register in the future, it would require approximately 12 work hours to accomplish the required actions, at an average labor rate of $65 per work hour. Required parts would cost $25,537. Based on these figures, the cost impact of this AD would be $26,317 per airplane. \n\n\tThe manufacturer may cover the cost of replacement parts associated with this AD, subject to warranty conditions. Manufacturer warranty remedies may also be available for labor costs associated with this AD. As a result, the costs attributable to the proposed AD may be less than stated above. \n\nDetermination of Rule's Effective Date \n\n\tSince this AD action does not affect any airplane that is currently on the U.S. register, it has no adverse economic impact and imposes no additional burden on any person. Therefore, prior notice and public procedures hereon are unnecessary and the amendment may be made effective in less than 30 days after publication in the Federal Register. \n\nComments Invited \n\n\tAlthough this action is in the form of a final rule and was not preceded by notice and opportunity for public comment, comments are invited on this rule. Interested persons are invited to comment on this rule by submitting such written data, views, or arguments as they may desire. Communications shall identify the Rules Docket number and be submitted in triplicate to the address specified under the caption ADDRESSES. All communications received on or before the closing date for comments will be considered, and this rule may be amended in light of the comments received. Factual information that supports the commenter's ideas and suggestions is extremely helpful in evaluating the effectiveness of the AD action and determining whether additional rulemaking action would be needed. \n\n\tSubmit comments using the following format: \n\nOrganize comments issue-by-issue. For example, discuss a request to change the compliance time and a request to change the service bulletin reference as two separate issues. \n\nFor each issue, state what specific change to the AD is being requested. \n\nInclude justification (e.g., reasons or data) for each request. \n\n\tComments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the rule that might suggest a need to modify the rule. All comments submitted will be available, both before and after the closing date for comments, in the Rules Docket for examination by interested persons. A report that summarizes each FAA-public contact concerned with the substance of this AD will be filed in the Rules Docket. \n\n\tCommenters wishing the FAA to acknowledge receipt of their comments submitted in response to this rule must submit a self-addressed, stamped postcard on which the following statement is made: "Comments to Docket Number 2003-NM-140-AD." The postcard will be date stamped and returned to the commenter. \n\nRegulatory Impact \n\n\tThe regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132. \n\n\tFor the reasons discussed above, I certify that this action (1) is not a "significant regulatory action" under Executive Order 12866; (2) is not a "significant rule" under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES. \n\nList of Subjects in 14 CFR Part 39 \n\n\tAir transportation, Aircraft, Aviation safety, Incorporation by reference, Safety. \n\nAdoption of the Amendment \n\n\tAccordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows: \n\nPART 39-AIRWORTHINESS DIRECTIVES \n\n\t1. The authority citation for part 39 continues to read as follows: \n\n\tAuthority: 49 U.S.C. 106(g), 40113, 44701. \n\n§ 39.13 (Amended) \n\n\t2. Section 39.13 is amended by adding the following new airworthiness directive: