2003-15-07 Honeywell International Inc. (formerly AlliedSignal): Amendment 39-13250. Docket No. 2002-NE-42-AD.
Applicability
This airworthiness directive (AD) is applicable to Honeywell International Inc. (formerly AlliedSignal) model RE220 (RJ) auxiliary power units (APUs) part number (P/N) WE3800770-2. These APUs are installed on, but not limited to Bombardier model CL-600- 2C10 airplanes.
Note 1: This AD applies to each APU identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For APUs that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (e) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed bythis AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.
Compliance
Compliance with this AD is required as indicated, unless already done.
To prevent APU compartment fires and fuel vapor explosion, do the following:
(a) Within six months after the effective date of this AD, replace APU fuel nozzles, P/N WE3830486-2, with new design fuel nozzles, P/N WE3830513-1. Information on fuel nozzle replacement can be found in Honeywell International Inc. alert service bulletin (ASB) RE220-49-A7714, dated November 4, 2002.
(b) Reidentify the APU as follows:
(1) Change the P/N from WE3800770-2 to WE3800770-3 on the identification plate, by removing the -2 and vibropeening or hand stamping a -3 in its place.
(2) Vibropeen or hand stamp the letter "C" after the serial number to show conversion.
(3) Vibropeen or hand stamp "Change Number 3" on the identification plate adjacent to the MODRECORD.
(c) Start the APU and perform a visual fuel leak check after one minute of operation.
(d) After the effective date of this AD, do not install fuel nozzles P/N WE3830486-2 into any APU P/N WE3800770-3.
Alternative Methods of Compliance
(e) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Los Angeles Aircraft Certification Office (LAACO). Operators must submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, LAACO.
Note 2: Information concerning the existence of approved alternative methods of compliance with this airworthiness directive, if any, may be obtained from the LAACO.
Special Flight Permits
(f) Special flight permits may be issued in accordance with 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be done.
Effective Date
(g) This amendment becomes effective on September 3, 2003.